Maplin Portable Satellite Reciever Manual

INSTRUCTION MANUAL MODEL: CD- 07

PE BOX

COLOR MAY BE DIFFERENT WITH THE PRODUCT

DISH ANTENNA

The pictures contain optional parts and may not be the same as the real products.

SUCTION STAND WALL MOUNT BRACKET

LNB ARM, LNB CLAMP AND LNB SAT-LOCATOR

C -CLAMP SQUARE ROD

PARTS & ACCESSORIES The parts and accessories are varied from different models and options. z

PE box

z

Dish antenna

z

LNB arm and clamp

z

LNB

z

( optional )

z

C-Clamp and square rod

z

( optional )

z

Suction stand

z

( optional )

z

Satellite locator

z

( optional )

z

Wall mount bracket

z

( optional )

SAT-LOCATOR

LNB ARM

LNB ARM

DISH ANTENNA

SQUARE ROD

C CLAMP

C -CLAMP

WALL MOUNT BRACKET

WALL BRACKET

SUCTION STAND

LNB & CLAMP

LNB CLAMP & ARM The LNB is clamped in the LNB holder (clamp),either pre-fitted or customer-fitted in

LNB ARM

the holder, can be snapped into the recess with the “ARM�. (see figure right)

Snap in

PE BOX RECEPTION LNB & holder clamp The PE box can be used as the support stand for the satellite reception.

1.

Open the lid of the PE box, secure the lid position by tightening the butterfly-nut.

2.

Snap the LNB & clamp into the ARM.

3.

Snap the ARM into the recess hole of the DISH antenna (see the figure below).

4.

The elevation angle of the antenna can be adjusted by changing the angle of the lid.

Adjust the lid for elevation

Snap into the DISH

NOTE: Put some weight in the PE box will help to balance the DISH antenna from being tipping down by the wind.

ATTENTION！ 1. This satellite antenna is a Ku- band mobile reception system which can only be used under a steady condition, it can not be used in a moving vehicle or any unstable platform.

2. The reception threshold is restricted by the gain power of the DBS satellites and the reception site, please check the foot-print of the satellite (can be assisted by your dealer ).

If the gain power is

lower than the threshold , the picture of the TV will appear “ snow ” or “ spark ”, or without voice and color.

If the gain power is much lower , it will be no picture at all.

USE OF WALL MOUNT 1.

Position the Wall mounting bracket on the southward wall, secure the wall mounting bracket by wall bolts which are included in the polybag.

2.

Position the Square rod to fit into the square recess of the wall mounting bracket, secure the square rod by tightening the wing nuts.

3.

Place the Dish/Arm/LNB/Clamp assembly on the Square rod by fitting the ball joint end into the hole of the end of

SQUARE ROD

the Square rod.

4.

Secure the Dish assembly by tightening the thumb bolt.

CLAMP ON VERTICAL POLE 1.

Position the C clamp to clamp on the pole.

2.

Fit the Square rod into the square recess of the C clamp and push to the end.

3.

Tighten the thumb bolt to secure the Square rod.

4.

Place the Dish assembly on the end tip of the Square rod.

5.

Aligning the end of the ball joint to the hole of the Square rod, secure the Dish assembly by tightening the thumb bolt.

SQUARE ROD