DIGITAL DESIGN + FABRICATION SM1, 2015 M1 JOURNAL - Plant Support Jichuan Yu
657686 Tutor Name :Paul Loh Thursday 11-1w
1
Measured Drawings
Measured Drawing Front View
2
Measured Drawing Top View
11 mm
I made a circle with sticky tape and then used ruler to measure the length of the sticky tape to determine the radius. The radius of the circle would then help in constructing the 3D model.
90 mm
Making a right triangle by using sticky tapeww to determine the angle that the sticks rotate from vertical direction.
The length of each stick in this plant suppport is directly measured with tape measure.
3
Analysis
Firstly, I tried to consider this geometry of the plant support is formed by this single units.
4
And 9 units of that can form the shape.
Another way to consider the geometry
Two circles formed firstly on the top and bottom.
Then those sticks array around the circle.
5
Digital Model
6
Process of Digital Modelling
Using the angle I measured, I can determine how much it rotates from the vertical direction.
Firstly, I made two sticks as a single unit.
And then using “Polar array� command to finish the whole geometry 7