CRYSTAL SERIES
REVOLVING DOOR TECHNICAL MANUAL
AGP Door Systems Pty Limited
OUTLINE
Offering the ultimate in customisable revolving door design, the AGP Crystal Series features an elegant glass roof and slimline steel portal frame. It offers various glass fixing options to suit the architectural requirements of the client and provides a modern spacious appearance to the entrance foyer of any building. This door can be built in either 3 or 4 wing configuration and is avaiable with fixed door wings only. The electrical motor drive can be contained in a pit in the concrete slab, or if there is a suspended slab, it can be mounted to the underside for ease of access when servicing. Despite its highly transparent nature, the Crystal series is equipped with all the modern safety sensors to ensure optimum safety at all times. The slimline steel support structure, the design of which is customised for each project, can be clad with stainless steel, aluminium or brass.
>ÃÃÊÀ v
- iÊÃÌii ÃÕ«« ÀÌÊÃÌÀÕVÌÕÀi
ÌÀ ÊÃÜ ÌV «> i
ÕÀÛi`Ê} >ÃÃ Ã `iÜ> Ã
ÕÌÌ
2
À> i iÃÃÊ} >ÃÃ ` ÀÊÜ }
- V iÊ Ì
DIMENSION DETAILS
A
2100 - 3200
3 LEAF CONFIGURATION
FLOOR LEVEL
B
PLAN
ELEVATION
‘A’ O/A Diameter
2800
3200
3600
4000
4400
‘B’Opening
1300
1500
1700
1900
2100
A
2100 - 3200
4 LEAF CONFIGURATION
FLOOR LEVEL B
PLAN
ELEVATION
‘A’ O/A Diameter
3600
3800
4000
4200
4400
‘B’Opening
2442
2584
2725
2867
3008
NOTE: Doors can be custom built to your exact size
3
LOCATION OF THE DRIVE UNIT
OPTION A - MOUNTED UNDER CONCRETE SLAB Should the revolving door be located on a suspended slab, with a basement or underground parking below, the preferable option is to bolt the drive unit to the underside of this concrete slab with a 100mm diameter core hole drilled in the slab to enable the drive axle of the
xää
revolving door to control the door set.
*"7 ,
/
£ää
, 6 Ê1 / £Óää
OPTION B - CONTAINED IN PIT IN CONCRETE SLAB When there is no under slab access, the alternative is to build a pit into the concrete slab which will house the drive unit. Separate conduits will be required to allow power and data cables to be connected to the drive unit, and suitable drainage will be required should any water penetrate the pit. A removable floor inside the revolving door is fi tted to allow for access to the drive unit for servicing.
xää
4 *"7 ,
/
, 6 Ê1 /
£Óää
,
STANDARD FEATURES
CLADDING Doors can be supplied in a range of finishes
SPEED ‘SLOW DOWN’ BUTTON
including powdercoated and anodised
All doors are fitted with an illuminated push
aluminium, stainless steel and brass. All
button that will slow the door down to half
cladding is folded over to provide a neat finish
of its normal speed for 2 revolutions. This
with no visible fixings.
will make the revolving door more safely
‘REMOTE’ mode
accessible for wheelchair users and elderly
This mode is used when the door is connected
people.
to a remote security system that will
LOCKING Electric locking of the doorset is built into the
C. Mode Key Switch The four position mode switch can have the key removed in any position leaving the door set in that particular operational mode. The functions of the control switch are as follows;
automatically switch the door from lock mode
drive motor to provide a secure entrance at
CONTROL SWITCH PANEL
to run mode on a programmed basis.
night. Please refer to the following page for
All doors are fitted with a control switch panel
‘RUN’ mode (automatic operation)
further information.
that has a number of features
The door will run automatically. If the door is connected to a security system for remote
STEEL SUPPORT FRAME
operation the run mode will override any signal from the security system.
The steel support frame is custom engineered to suit the size of the revolving door, the architectural preferences for the door
‘LOCK’ mode
A
The door will rotate to the lock position and
EMERGENCY
appearance, and any specific loading
automatically lock. This mode will override a
STOP
signal from a remote security system.
requirements of the overhead glazing.
B
‘STOP’ mode The door will stop in the locking position but
All glazing within the revolving door meets to the revolving carousel is 12mm toughened. The glass to the sidewalls is 8mm toughend
the door will not lock.
REMOTE
C
STOP
the requirements of AS1288:2007. The glass
LOCK
GLASS
RUN
RUN
and the glass roof is 15mm toughened. These
AGP DOOR SYSTEMS
thicknesses are submitted to engineering
1800 674 408
analysis. All glass is clear with other options, such as low iron or tinted, available upon request.
A. Mode and Fault Indicator LED’s The 3 indicator LEDs are designed to indicate
DOOR OPERATION All Crystal doors are be programmed to operate
the current status of the four position mode key switch as well as any fault indications
at a constant run speed during normal
The LEDs will either be switched constantly
operation. As mounting of radar sensors to
on, slowly flashing or fast flashing and can
the glass roof would detract from the doors
be in any combination of these to give a
appearance, Stop-Run operation would only
particular mode or fault indication.
be provided upon special request.
B. Emergency Stop Button When the button is pressed the door will stop immediately.
5
CASE STUDIES
AMP SYDNEY COVE Circular Quay [2002]
1D HOMEBUSH BAY DR. Rhodes [2003]
SIR KEITH MURDOCH HOUSE Adelaide [2006]
As part of the ground floor lobby refurbishment of this landmark building opposite Circular Quay, two 3500m diameter, 3 wing Crystal series revolving doors were installed. In keeping with the heritage appearance of the building, specially extruded aluminium sections were made for the door support structure, providing the appearance of steel universal beams and matching the surrounding glazing details.
With a bold a strike first impressive desired,
To provide a prestige entrance for one of
a large 4000mm diameter, 4 wing Crystal
Adelaide’s most significant commercial
Series revolving door was installed as the
building developments, a 3000mm diameter,
main entry to this new commercial building.
3 wing Crystal series revolving door was
To maximise the open and clean appearance,
selected. The door features a frameless glass
the door was specially engineered to support
roof suspended below the steel portal frame
the dead loads and wind loads imposed by
with spider fittings as well as curved sliding
the frameless glass screen above, without the
night doors which manually slide across a
need for a separate entry portal. To achieve
tubular track to seal off the door entrance at
this, 150 x 100mm RHS steel members were
night.
Builder: Australand
Glazier: Kingswood Aluminium
Builder: Probuild
Glazier: Architectural Glass Projects
Glazier: Architectural Glass Projects
Architect: Fender Katsalidis
Architect: Nettleton Tribe
Architect: Peddle Thorp Walker
6
used for the door support structure.
Builder: Baulderstone Hornibrook
SAFETY FEATURES
MULLION SAFETY SENSORS
DOOR LEAF SAFETY SENSORS
DOOR RAIL SAFETY SENSORS
The AGP mullion safety sensors provide
The AGP door leaf infrared safety sensors
The AGP Door rail contact safety sensors
optimum safety between the leading
are fitted to the top door rails and scans
are fitted to the front of each door leaf.
edge of the mullion and the approaching
the area directly in front of each door
Should a person’s foot come into contact
revolving door leaf.
leaf.
with the bottom rail the revolving door
If an object is detected in front of the
Should a person be detected the door
will immediately stop.
leading mullion when the door leaf
will slow down to the speed of the
The system is designed to stop the
is within a distance of 500mm from
person and if necessary stop.
revolving door should the infrared sensor
the leading mullion the door will stop
The system is designed to minimise the
fail to pick up the obstruction earlier.
rotating until the object
possibility of collision between each
The AGP door rail safety sensors
has moved from the safety zone.
revolving door leaf and a person or
comply with the Australian Standard on
The AGP mullion safety sensors comply
object inside the revolving door.
Revolving Doors AS5007:2008
with the Australian Standard on
For elderly or handicapped persons the
Revolving Doors AS5007:2008
ability of a door to slow down to the same speed as they are walking has real safety advantages. This system is ideally suited for larger doors when there is more space inside each door quadrant. The AGP door leaf safety sensors comply with the Australian Standard on Revolving Doors AS5007:2008
7 Images Front: 800 Bourke Street, Dockland Page 2: 80 Shortland Street, Auckland Back: 135 King Street, Sydney
In Pursuit Of Excellence 9 Liberty Road Huntingwood NSW 2148 T (+61) 02 9671 0000 F (+61) 02 9672 1951 W www.agpgroup.com.au
A proudly Australian owned and operated company, AGP Door Systems Pty Limited is a specialist designer, manufacturer and installer of a wide range of automatic and manually operated revolving doors and high security entry/exit systems. The Crystal Series revolving door continues to push the boundaries of revolving door technology and structural glass engineering. Every Crystal door can be considered truly unique, with AGP working closely with each client to build a striking entrance that complements the architectural vision of the building. With the Crystal Series, there are no compromises.