installation In order to guarantee the correct operation of the monoblock, to optimise its electrical consumption per Kg of stored product and to prevent breakdown, it is vitally important that it is placed in a suitable location and properly used.
CONDENSER
- Ensure that air is circulating through the condenser. - Locate it away from sources of heat. - Ensure that the air entering is as fresh as possible and that the air exiting is not mixed with it. - Ensure that there is enough space around the air inlets and outlets. - Keep the condenser clean. - Seal any points through which air could enter from outside. - Provide an access point for maintenance and repairing. - Avoid direct contact between the plates by means of a door seal. - Provide a drain tube for condensation. - The electrical supplies must be protected by suitable magnetothermic switches and differential switches.
Block
W A L L - M O U N T E D
M O N O B L O C K
QUALITY & SAFETY
U N I T
commercial range
EVAPORATOR
- Make sure the cold room door is only open when strictly necessary. - Do not place very hot food inside the cold room (it is not a freezer). - Do not place food for freezing in the cold room (it is not a freezing tunnel). - Leave room for air circulation. Observe the load limits indicated on the enclosed diagram. - Seal any points through which air could enter from outside.
Supply cable
Polyurethane sealing
562
L UA
C MA
IR
O
DETAIL A
A
N
ENV
Drain tube (not included)
R
TIFI
ISO-9001/00 ER-0110/1993
ISO-14001/04 GA-1997/0017
GE
NM
D
Polyurethane sealing
ITY S Y ST E E
E
Q
Maximum height of Product
Y M ENT S
S
Y EN TAL S
Door seal
Connection tube to drain
Polyurethane panel
TOTALLY COMPACT COOLING
7- 2008
595
EM
438
EM
438
595
T
I = height
380
ST
H = width
M
FREE AREA FOR AIR INTAKE AND MAINTENANCE
PANEL CUTTING
Wose scope's the design, development and production, of insulating sandwich panels of polyurethane, polystyrene and mineral wool, and doors for cold and air-conditioned rooms and for other enclosed facilities.
Polígono Gardotza s/n 48710 BERRIATUA, Bizkaia Tel: +34 94 603 62 08 Fax: +34 94 603 62 21 e-mail: kide@kide.com http: www.kide.com
CONNECTION TO DRAIN: EXT. ø 13 MM We reserve the right to modify this document at any time without prior notice.
technical characteristics R-404-A
COOLING 4ºC / 0ºC COLD ROOM VOLUME
MODEL KCWU-105-M-1-Z
100
200
300
COOLING STANDARD NON CONTROLLED NOMINAL CAPACITY CONDITIONS (1) CONDITIONS (2) W POWER KW. m3 m3 833
5,1
4
0,36
TYPE
VOLTAGE
Hermetic 230/1/50
OTHER MONOBLOCK TECHNICAL DATA
electronic control
The KIDE wall-mounted monoblock unit is a totally compact cooling unit, simple to install and with easy access to the inside of the unit, making maintenance simple, quick and safe. It provides a high degree of operating safety as its circuit is totally welded and ready for mains connection.
Kide monoblocks have an easy-to-use standard electronic control.
NOMINAL CONDENSER EVAPORATOR MAXIMUM WEIGHT CONSUMPTION FLOW FLOW CONSUMPTION KG A m3/h m3/h A 4,15
780
780
4,8
It is constructed in treated sheet metal with a prepainted finish Its batteries are built with copper tube and aluminium fins The evaporator is forced draught type, with air condensation The compressor is hermetic type and runs on refrigerant gas R-404-a
56
KCWU-106-M-1-Z
1011
8
6
0,44
Hermetic 230/1/50
4,6
780
780
5,7
58
KCWU-107-M-1-Z
1252
10
8,5
0,55
Hermetic 230/1/50
5,2
780
780
6,4
58
KCWU-108-M-1-Z
1458
12
10
0,6
Hermetic 230/1/50
4,9
780
780
5,9
60
KCWU-209-M-1-Z
1721
17
14
0,75
Hermetic 230/1/50
5,7
1560
1560
6,7
85
KCWU-210-M-1-Z
1976
21
16
0,9
Hermetic 230/1/50
7,1
1560
1560
8,4
88
KCWU-215-M-5-Z
2223
26
21
1,1
Hermetic 400/3/50
3,7
1560
1560
4,6
90
KCWU-317-M-5-Z
2843
37
29
1,3
Hermetic 400/3/50
3,6
1780
1780
4,6
98
KCWU-320-M-5-Z
3712
44
35
1,5
Hermetic 400/3/50
4,6
1780
1780
5,8
100
R-404-A
FREEZING -18ºC / -20ºC COLD ROOM VOLUME
SERIES
100
200
300
MODEL
COOLING STANDARD NON CONTROLLED NOMINAL CAPACITY CONDITIONS (1) CONDITIONS (2) POWER KW. W 3 m m3
COMPRESSOR DATA TYPE
VOLTAGE
539
3,8
3
0,55
Hermetic 230/1/50
4,4
780
780
6
58
KCWU-110-L-1-Z
784
5,5
4
0,75
Hermetic 230/1/50
4,1
780
780
6
58
KCWU-115-L-1-Z
1089
8,5
6,5
0,95
Hermetic 230/1/50
5,8
780
780
8,7
60
KCWU-215-L-1-Z
1200
11
8,5
0,95
Hermetic 230/1/50
6,3
1560
1560
9,2
85
KCWU-217-L-5-Z
1300
15
10
1,3
Hermetic 400/3/50
3,3
1560
1560
4,8
88
KCWU-317-L-5-Z
1491
22
15
1,3
Hermetic 400/3/50
2,8
1780
1780
4,5
98
KCWU-320-L-5-Z
1986
31
21
1,5
Hermetic 400/3/50
4,3
1780
1780
7,4
100
CONNECTION TO DRAIN: EXT. ø 13 MM
Cold room light button Economy mode button
Max. temperature and quick cooling button
ALARM DESCRIPTION
P1
Temperature sensor failure
P2
Defrost sensor failure
HA
Maximum temperature alarm
LA
Minimum temperature alarm
PAL
Pressure switch error
EE
Programming error
Min. temperature button On/off button
Temperature setting and parameter validation button
PARAMETER
Electronic condensation control for cooling units Evaporator and/or condenser with cataphoresis treatment Unit synchronisation control Remote control
D I M E N S I O N S
PARAMETER DESCRIPTION
UNIT OF MEASUREMENT
COOLING
FREEZING
Set
Functioning temperature
ºC
2
-18
Hy
Temperature difference
ºC
2
2
AC
Off/On safety time
min
7
7
dtE
End of defrost temperature
ºC
10
15
IdF
Defrost interval
h
6
6
MdF
Maximum defrost temperature
min
45
45
ALU
Maximum temperature alarm
ºC
10
-5
ALL
Minimum temperature alarm
ºC
-5
-35
NOTE: The parameters must only be modified by qualified staff, under their responsibility.
A
UNIT B
C
100
783
446
811
100
995
495
862
70
80
200
853
661
910
200
1065
720
961
100
110
300
993
663
977
300
1215
720
1030
110
120
SERIES
ALARMS
Defrost button
Alarm indicator light
Options:
NOMINAL CONDENSER EVAPORATOR MAXIMUM CONSUMPTION FLOW FLOW CONSUMPTION WEIGHT KG A m3/h m3/h A
Digital display
Quick cooling mode indicator
Totally integrated remote standard multifunctional electronic control Capillary system for refrigerant expansion Automatic defrosting by hot gas System for partial evaporation of defrosting water High and low pressure control Interior cold room light and 2.5 m cable 2.5 m cable for door micro switch Electronic condensation control (freezing units only) 2.5 m supply cable
OTHER MONOBLOCK TECHNICAL DATA
KCWU-107-L-1-Z
Defrost indicator light
The KIDE wall-mounted monoblock units are equipped with:
CONNECTION TO DRAIN: EXT. ø 13 MM
Compressor indicator light
Fan indicator light
SERIES
UNIT + PACKING A B C
WEIGHT Kg Standard Packing Shipping Packing
remote control
To know the status of the cooling unit remotely and in real time.
COOLING UNIT
TELEPHONE LINE E-MAIL
Packing MOBILE PHONE
SMS (with GSM modem only)
MODEM
(1) Standard: insulation 100 mm for cooling and 120 mm for frozen items; load density 250 Kg/m3; movement of goods 10% ; ambient temperature 35ºC; maximum entry temperature of goods 25ºC for cooling and -15ºC for frozen items; specific heat of goods 0.77 KJ/Kg ºC for cooling and 0.44 KJ/Kg ºC for frozen items; compressor functioning hours 18 h. per day. (2) Recommended volume for cases where starting data are not available for calculation or where conditions are more extreme than standard e.g. low thermal insulation capacity of cold room, low impermeability power of cold room, not insulated floor, aggressive external conditions, destination and use of the cold room in extreme conditions, etc.
Data Receiver USB Cable
SERIES
COMPRESSOR DATA
structural data
FAX
ROUTER
ISP-supplier
MOBILE PHONE
PDA
Shipping Packing MINICOMPUTER
MODEM
INTRANET
REMOTE PC
LOCAL PC INTERNET LINE REMOTE PC