Figure 2
Case study: Ford Fiesta EDWARD GRIGG OF SWANLEY GARAGE SERVICES, WITH THE HELP OF TRAINER STEVE SCOTT OF SIMPLY DIAG, IS CALLED OUT TO INVESTIGATE A NONSTART AND A CUSTOMER’S ATTEMPT AT GOOGLE DIAGNOSTICS We had a request to attend a non-start at a customer’s house. This is not something I usually offer but as Steve was with me, we decided to tackle this job, mobile.
CASE STUDY
The customer had parked their car for several days. The battery had gone flat and after recharging the battery the car refused to start. The customer took to Google to see what the problem could be. He read that he should change the instrument cluster along with the PCM, key and barrel – none of which fixed the fault. He had been trying for months to acquire codes to program the immobiliser and also sent off their instrument cluster to an electronic repair specialist. Unfortunately, every avenue the customer explored, failed. Before attending the job, I asked the customer to fit all the original parts back on so that I could make a fresh start on it.
12
We turned on the ignition and tried to start the car. The ignition came on, but the PATS light flashed and would not start. We noticed that the engine light did not illuminate – this is a tell-tale sign that the PCM (engine control module) is not communicating. We carried out a global scan of the vehicle, something we do on all diagnostic jobs in order to evaluate the full picture. We could see from the scan that we had lost communication with the whole of the powertrain CAN. We opened the bonnet to access the under-bonnet fuse box. We checked the fuses for engine management, and they were all dead.
At this point, we felt that we should seek some technical information and formulate a plan of how we were going to tackle the problem. We pulled up a wiring diagram using the Hella information system. We could see that the engine management fuses were only live after the main relay was energised. We located the relay and tested it. The relay was good, but it wasn’t being energised Figure 1 when the ignition was turned on. We had power to the relay, but the engine ECU wasn’t providing the earth path required for the relay to operate correctly. We decided to check the power and grounds to the PCM. We found that the PCM was missing one of the live feeds, the blue and red one that you can see in the diagram next to the relay, see Figure
