SPECIAL FEATURE: DAVID'S BOX FRAME

Box FrameDavid’s -------------------------------------------- BOX FRAME -------------------------------------------------

What you’ll need:

• 11-01-Box Frame SVG files • Red cardstock • Black cardstock • Cadence Dora Gilding

Wax - Gold

PROJECT 11

1Cut all the pieces needed to create the project as listed below;

From SVG downloads:

• From red cardstock: - 2 x BF-1-Hinge - 4 x BF-1-Fastener - 1 x BF-1-Eiffel Tower Outline - 1 x BF-1-Big Ben Outline - 1 x BF-1-Statue Of Liberty Outline • From black cardstock: - 4 x BF-1-Lace Panel 1 - 4 x BF-1-Lace Panel 2 - 1 x BF-1-Eiffel Tower - 1 x BF-1-Big Ben - 1 x BF-1-Statue Of Liberty

From machine memory:

• From red cardstock: - 1 x 152mm square

2Cover all your black cuts with gilding wax and leave to dry. When dry buff them with a paper towel to give them a more matte finish.

3Trim the hinges into eight rectangles approximately 3cm long. Fold the trimmed hinges in half and attach two of the fastener cuts together using one of the hinge pieces. Attach the rest of the fastener cuts to each other using the hinge pieces. This will form the box frame sides.

4Create the box by attaching the open ends together using another hinge piece.

5Mat the red square onto the bottom thinner tabs of the box frame sides. 6 Using the remaining hinge pieces, attach the top thicker tabs of the box frame together.

7Mat the lace panel 1 cuts onto the four tabs of the box frame.

8Mat the lace panel 2 cuts onto the four sides of the box frame.

9Push the joined tabs into the box frame to create an inner bevel. 10Mat the gold landmark cuts onto the outline cuts and mat into the box frame with foam tape. Add an extra layer of foam tape from the left to the right.

1 2 3

4

6 7 5

8