Drill the masonry according to the drills of the profile (you may use the profile as template ) and drown the M12 rods leaving the necessary prominence for the thickness of the profile and for the M12 nuts.
Place the profile in position and start fixing it. Cut the rods if they stick out of the nut.
Tight the nuts.
Pre-installed
Spread out the accessories to block the glass as per the attached image. 4 adjustesr go to the back and 4 to the front. The example considers a 2m long canopy. Insert the glass and tighten the registers until you secure the glass.
Anti-fall glass-safety fastener
Insert the anti-fall glass safety fastener and tight the nut very well, to prevent glass from accidentally unfasten itself and slide out of the clamp.
You can regulate the slope of the glass by using the two rows of adjusters: the one to the front and the one to the rear.
In order to move the glass high up, loose the rear adjusters and tight the front ones.
On the contrary, in order to move down the glass slope, loose the front adjusters and tight the rear ones. Once you find the desired slope, tight mildly the adjusters.
Adjusters to regulate the glass slope
1° 5°
Adjusters to regulate the glass slope
Plastic presser
Plastic presser Plastic presser
175 400 225 400 225 400 175
Plastic presser Plastic presser Plastic presser
Plastic presser
After having registered the glass slope, tap the 40 cm plastic presser inside the profile.
This operation is needed to discharge the load from the adjusters and distribute it to the pressers.
Lateral end cap.
Snap shut cladding to be inserted.
Cladding in position.
Insert the cladding and screw the lateral end cap to complete the job.