LineLED Layout guide
Lighting for the future, today.
1. ORDERING Sample LineLED strip components
male end connector (multiple options available)
solder pads
ordering and cutting increment
powerfeed connector
wires to power supply
Cutting increment and maximum run lengths with PSD-96-24 LL18
every 4 inches up to 100 feet
LL30
every 2.5 inches up to 48 feet
LL36
LLX18
every 2 inches up to 39 feet
every 4 inches up to 25 feet
Multiple strip powerfeed LLX22
LLXX18
LL36X2 REV0.0
every inch up to 23 feet
every 4 inches up to 9 feet
every inch up to 16 feet
Parallel powerfeed: for power consumption add the separate lengths individually (larger power consumption)
page 1 of 4
Powerfeed in series with flexible connector: for power consumption consider both strips as one continuous length (lesser power consumption)
www.luminii.com
LineLED Layout guide
Lighting for the future, today.
2. MOUNTING Securing strip in place
Multiple powerfeed layout
wires to power supply
Power supplies at ends heat sink tape LineLED strip
mounting clip CL -1
12.00”
power supply mounting surface
LineLED strip
12.00” place mounting clips every 12 inches for down-facing damp installations and every 6 inches for down-facing wet installations - if LineLED is installed facing up, no mounting clips are necessary
OR
12.00” 12.00”
Power supplies in the middle
Securing strip within extrusion endcaps and mounting brackets are ordered separately
LineLED strip wires to power supply
REV0.0
minimun quantity 2 mounting brackets per extrusion - 3 brackets required for 78” lengths and 4 brackets required for 118” lengths
place extrusions end to end to extend runs
LENS if required for installation purposes extrusion and lens can be cut to size always cut extrusion and lens assembled together to precisely match lengths and also avoid cracking of the lens
page 2 of 4
Consecutive layout is not recommended
www.luminii.com
LineLED Layout guide
Lighting for the future, today.
2. MOUNTING Straight and curved mounting surface
LED strip does not curve horizontally, only vertically!
vertical straight mounting horizontal straight mounting vertical curved mounting
SECTION OF STRAIGHT MOUNTING SURFACE
REV0.0
horizontal mounting to curve (broken into segments to create curve - based on available width)
SECTION OF CURVED MOUNTING SURFACE
page 3 of 4
www.luminii.com
LineLED Layout guide
Lighting for the future, today.
3. OPERATION Preparation for operation and dimming diagram
Dimmer view Luminii website for list of compatible dimmers
Power supply install in remote well ventilated area - ensure LineLED load does not exceed recommended power supply load
LineLED always test LineLED before installing to ensure proper functionality
class 2 dimming power supply
line voltage wires
REV0.0
low voltage dimmer
LineLED strip
page 4 of 4
www.luminii.com