Digital Readout Installation
Figure 1.1
Cast iron fence support
Figure 1.2
Digital display kit
Figure 1.3
Remove bottom bracket from the digital display
Figure 1.4
Slide off the secondary bracket from the digital display
1
Figure 1.5 Install 2 AA batteries as recommended.
Figure 1.6 Slip cord with sensor thru the hole of the digital housing
Figure 1.7
Slip the digital display into the housing. It will be a snug fit
Figure 1.8
Completed display
2
Figure 1.9
Slip cord with sensor thru the hole of the cast iron fence support
Screw nut tight to the digital the assembly
Figure 2.1
Bracket, bolts, and sensor
Figure 2.0
Figure 2.2
Bracket, bolts, and sensor assembly
3
Figure 2.3 Bolts
Figure 2.4
¾”
Attach sensor assembly underneath the cast iron fence support with two bolts and space middle of sensor to edge as shown about ¾”
Remove original tape L bracket if already installed
Figure 2.5
Install new tape L bracket with channel
Figure 2.6
Magnetic tape roll (thin strip of metal and magnet strip)
4
Figure 2.7
Apply the magnetic strip in the channel of the tape L bracket. Start at the zero mark
The magnetic strip and thin strip of metal will be longer than the tape L bracket
Figure 2.9
Cut the magnetic strip at the end of the tape L bracket
Figure 2.8
Figure 3.0
Apply the thin strip of metal on top of the magnetic strip and trim at the end
5
Figure 3.1
Figure 3.2
From underneath you can check that the sensor is center and above the tape. Distance from sensor and tape should be about 1/16�
Install the fence assembly
Figure 3.3 Apply the vinyl measure tape on top of the tape L bracket. You can apply the measure tape with or with out the fence assembly on
Figure 3.4 Completed assembly
6