B161500%3AProgramming+the+Digital+Display

Page 1

Programming the Digital Display 1. Turn on display 2. The display normally will be set for German language. You will need to change it to English. 3. Press and hold the P button for about 3 seconds or bars at upper right hand corner are gone then you will be the program mode. 4. Then keep pressing the P button till you have reached the last mode SPr. The Spr mode is defaulted to d. By pushing the up arrow key, change the mode from d (German) to E (English). Then press the * button to save. Keep on pressing the P button till the mode function ends. This mode will change to LAn (Language) after the setting is done. 5. Now that the digital display is in English language you will need to program the other modes. Press and hold the P button for about 3 seconds or bars at upper right hand corner are gone then you will be the program mode, as mentioned on #3 above. 6. Display rES will be blinking. Hit the up arrow key till desired metric or SAE setting. Standard setting will be at SAE up to 1/32�. Press the * button to save. (by pressing the * button at any time during the programming protocol you will be saving any changes). Then press the P button to move to the next mode. (By pressing the P button while in program mode will change to next mode till it ends) 7. The next mode is the ref (Reference) mode and this mode could be set at any number that is desired. Use the left arrow to move the desired digit and then the up arrow key to change the digit, standard setting will be at 010.000 but it could be set at any reference the operator wants to use. Press the * button to save then press P for the next mode. NOTE: the reference mode will be your calibration setting. Example, if you turn off the digital display and the fence was moved your digital display will not read the correct distance from the blade to the fence. By pressing the star button (*) (not in the program mode) it will change back to the reference setting as mentioned above #7, first make sure your fence is positioned at the reference number programmed before pressing the star button (*). 8. The next mode is the oFS (off set) mode and this mode will be set to the default at 000.000. Use the left arrow to move the desired digit and then the up arrow key to change the digit; standard setting will be at 000.000. Press the * button to save then press P for the next mode.

1


9. Keep pressing the P button to be in the rSto mode and this mode will be set to on by pressing the up arrow button. Press the * button to save then press P for the next mode or keep pressing the P button to reach the end of the program mode.

2


If the increase or degrease on the read out is opposite of the direction that you are moving the rip fence, there are two ways of correction. 1. Flip the sensor at the bracket. 2. Press and hold the P button for about 3 seconds or bars at upper right hand corner are gone then you will be the program mode. Keep pressing the P button till you are in the dir (direction) mode and press the up arrow key to change from up to dn (down) or vise versa, then press the * start button to save. After saving keep pressing the P button till you exit out of the program mode. Note: any other modes should not be changed other than what is mentioned above. On page 3 you will find the Laguna Tools factory settings.

3


Desired setting by Laguna Tools rES

Desired setting as mentioned on page 1

rEF

Desired setting as mentioned on page 1

oFS

000.000

dir

See bold instructions as mentioned on page 2

Auto

off

rSto

on

4_off

off

4_Abs

off

F_Abs

on

F_reL

off

F_rEF

off

F_oFS

off

LAn

E

4


Turn static files into dynamic content formats.

Create a flipbook
Issuu converts static files into: digital portfolios, online yearbooks, online catalogs, digital photo albums and more. Sign up and create your flipbook.