The Optimum Saddle Fit for Rider & Horse
Page 1
G. Passier & Sohn GmbH: The Business Foundation: Location: Employees: Portfolio: Main focus: Export:
1867 Langenhagen 80 Saddles, Bridles and Accessories English Riding (Dressage, Jumping, All-Purpose/Cross-Country) 50% of Production, World-Wide
Page 2
The Saddle Fit – Rider
Page 3
The Saddle Fit – Rider: Size and Weight of the Rider There should be space for the width of approximately four fingers between the back of the rider’s seat and the cantle
Page 4
The Saddle Fit – Rider: Saddle Tree Normal Seat
Deep Seat = Higher Cantle
Page 5
The Saddle Fit – Rider: Position / Length of Saddle Flaps Depends on the equestrian discipline When the stirrup leather is adjusted to the correct length, the riding boot should cover approximately four finger‘s width over the saddle flap
Page 6
The Saddle Fit – Rider: Support Is a question of personal preference: Modern thigh supports are large and voluminous = good hold for thigh and knee
Traditional knee supports are smaller = less support for the knee but more freedom of movement for the rider in the saddle: This makes it easier for the rider to find the right balance
Page 7
The Saddle Fit – Horse
Page 8
The Saddle Fit – Horse: General The saddle fit ensues from a) Gullet width b) Gusset flocking
Page 9
The Saddle Fit – Horse: Point of Gravity for the Saddle Correct The point of gravity is in the middle Incorrect a) The saddle is too low at the back, the rider sits in the rear third of the saddle >> Saddle pressure in the rear area >> Saddle slips forward b) The back of the saddle is too high, the rider is positioned too far forward >> The rider cannot sit properly
Page 10
The Saddle Fit – Horse: Wither Freedom Correct There should be enough space for up to two fingers to fit between the withers and the saddle >> Which fingers are meant here?
Incorrect Contact of withers and saddle >> Saddle pressure in the front area
Page 11
The Saddle Fit – Horse: Shoulder Freedom Correct The saddle is positioned behind the shoulder Incorrect The saddle is positioned on the shoulder >> The horse is restricted and cannot move freely >> Saddle pressure in the rear area >> Saddle slips forward
Page 12
The Saddle Fit – Horse: Freedom of the Spine Correct Maximum contact area whilst also allowing freedom of the spine >> The rider’s weight is distributed over as large an area as possible
Incorrect Channel too wide = small contact area of the saddle with the horse‘s back >> Serious problem of localized pressure points
Page 13
The Saddle Fit – Horse: Freedom Panels More space on both sides of the withers Wider channel in the first third of the saddle tree >> Greater freedom of movement
Page 14
The Saddle Fit – Horse: Flocking Correct Two-dimensional and even flocking
Incorrect Uneven flocking >> Saddle is crooked on the horse >> Rider’s weight imposes more strain on one side >> On the long term the saddle tree will also become crooked
Page 15
The Saddle Fit – Horse: Flocking Correct Soft flocking
Incorrect Hard flocking >> Causes saddle pressure
Page 16
The Saddle Fit – Horse: Position of the Saddle Girth Correct The saddle girth is positioned at a distance of approximately four fingers behind the horse’s elbow Incorrect The saddle girth is positioned very far forward >> Saddle slips forward Question What can you do in a situation when the horse is so barrel-like that the saddle girth always slips behind the elbow? >> Flocking >> Gullet plate width >> Girth strap arrangement >> Saddle girth Page 17
Correct Saddle Fitting
Page 18
Correct Saddle Fitting: 1. Establishing Contact The seller should ask about: The equestrian discipline The rider’s height The rider’s weight The type of horse The conformation of the horse >> On the basis of this information the seller selects some saddle types which would be suitable for the rider as well as the horse
Page 19
Correct Saddle Fitting: 2. Saddle Fitting at the Stable Saddle check on horse standing still, without rider - Put the trial saddle on the horse’s back, position it correctly and tighten the saddle girth - Assess the fit without the rider - Correct the fit if required Testing the saddle in movement Rocking, slipping or sideways instability can only be recognized when the horse is moving under the rider Measuring up Only necessary if the make of saddle which is ridden at the saddle fitting trial is not the same as the one which is later purchased Page 20
Correct Saddle Fitting: 3. Final Check at the Stable Final check If the saddle required alterations after the initial saddle fitting trial, the seller should come to the horse again afterwards in order to check for himself that the saddle meanwhile fits correctly Follow-up check Modern flocking materials are so stable that a further check-up after six weeks is no longer necessary – the saddle is only likely to drop to an extremely minimal extent
Page 21
Tips to Maintain the Correct Saddle Fit
Page 22
Tips to Maintain the Correct Saddle Fit: Tightening the Saddle Girth Incorrect Girthing up on the left side only Correct Also girthing up on the right side >> This prevents the saddle tree becoming crooked
Page 23
Tips to Maintain the Correct Saddle Fit: Flocking Incorrect Too frequent re-flocking Correct As a matter of principle, a saddle should only be re-flocked when it no longer sits well on the horse’s back or when the panels have become very hard >> In such cases it is recommended to take completely new filling Generally speaking, A saddle has to be re-fitted when the horse’s shape has changed or the panels have dropped significantly
Page 24
Tips to Maintain the Correct Saddle Fit: Flocking Incorrect Re-flocking by making a cut in the panel below the end of the large saddle flaps Correct Even, two-dimensional re-flocking >> For this purpose the panel has to separated from the upper part of the saddle Generally speaking There is no set period during which a saddle has to be re-flocked
Page 25
Tips to Maintain the Correct Saddle Fit: Mounting Incorrect The rider holds on to the cantle and pulls himself on to the horse >> The strain imposed predominantly on one side is detrimental to the horse as well as the saddle
Page 26
Tips to Maintain the Correct Saddle Fit: Mounting Correct The rider holds on to the saddle and pulls himself on to the horse Even better Use a mounting block to mount
Page 27
Thank you very much for your interest!
Page 28