Made in
A
m
bie n
te
20
00
Italy
BIKE surfaces SURFACES FOR BIKE TRACK
BIKE surfaces SURFACES FOR BIKE TRACK
APPLICATION
00
FunBike is the perfect surface for indoor and outdoor skate parks.
FunBike it’s a mixture of colored synthetic and elastic resins mixed with mineral obtained by a controlled granulometry (quartz sand).
20
The mixture is laid with no solution of continuity in intercrosses layers on predisposed foundation on impermeable asphalt with adapted slope (for outside only) of 1%.
te
FunBike is available in different colors and the resin is highly resistant to usury pigments tested under U.V. rays.
bie n
FunBike doesn’t need maintenance and it-s performances are granted during the years. The product doesn’t change with high or low temperatures. The cleaning it’s necessary with only water.
m
COLOR
Color available: GREEN, RED, BLUE, ORANGE, GREY, BLACK
A
• SPECIAL COLOR ON DEMAND
MATERIALS USED Synthetic soluble resins, highly resistant to usury, pigments tested under U.V. rays. This product is certified ISO 9001:2000, ISO 14001:2000, EN 1177, EN 71, 3rd part, certifying the product is toxicity free.
BIKE surfaces SURFACES FOR BIKE TRACK
TECHNICAL FEATURES Excellent resistance to abrasion, 10 YEARS GUARANTEE
AGING No change THERMAL SENSIVITY
te
Good elongation at break
20
ELATICITY
00
USURY
IMPERMEABILITY
bie n
Excellent stability at high and low temperatures
m
Fully Waterproof; 1% slope to the water flow sufficient slipperiness the graininess of the surface made with quartz sand or with the granules of terpolymer used in the dough, allow to obtain a non-slip surface MAINTENANCE
A
Not requires special maintenance
BIKE surfaces SURFACES FOR BIKE TRACK
APPLICATION INSTRUCTION
00
FunBIKE may be applied on well compacted and pressed new or old (asphalt) decks which should in any case be in good condition. Clean the deck thoroughly removing all traces of oil and grease.
20
No primer is required when applying on a new asphalt deck, but when retopping use Acrybase. IMPORTANT
bie n
te
resin surfaces are generally waterproof (non-draining) so that the deck must be sloped correctly to ensure rainwater runoff and pre-vent pooling. Works to correct the deck must be carried out before laying the final covering.
APPLICATION INSTRUCTION ON CLIMATIC CONDITIONS
m
Ambient temperature: MIN 10°C – MAX 40°C AMBIENT RELATIVE HUMIDITY: MAX 90%
A
DRYING AT 25°C AND 50% U.R. Surface
1h
To walk
2h
Interval between coatings
8h
The times indicated refer to standard laboratory conditions. Curing times are strongly affected by weather conditions; high temperature and direct sunlight accelerate curing; shade, low temperatures and high levels of humidity slow down curing. In winter, lay the product in the warmer hours of the day. Always allow the coating to dry perfectly before applying the next coating.
BIKE surfaces
00
SURFACES FOR BIKE TRACK
A
m
bie n
te
20
BIKE surfaces
Fun Bike Surfaces BIKE surfaces