spk008-2_im

SPK008 6x9 4 WAY Wake Tower

SPEAKER SYSTEM

Instruction leaflet

Installation instructions The wake tower speaker is designed to hang from a wake tower of diameter ranging from 40–50 mm (1.5”–2”).

Attaching the speaker to the Wake tower 1. Remove both nuts holding the top plate onto the bracket using a 4.75 mm (0.2”) allen key.

Speaker Cable wiring 1. T ake the two (2) supplied rubber grommets and snip off the end so a hole the diameter of your speaker cable is made. GME recommends the use of 6–10 mm (0.2” –0.4”) speaker cable depending on the cable run to your stereo or amp.

Speaker wire diameter

2. Place the rubber grommet over the end of the speaker cable. This needs to be done twice for each terminal on the speaker.

3. Once the grommets have been placed over the speaker wire, attach the wires to the terminals on the back of the speaker.

2. Remove the top plate.

3. Place the speaker and the top of the bracket around the wake tower in desired position. Screw in the nuts.

Self-adhesive rubber pad

4. Ensure the positive speaker cable is attached to the red terminal and the negative speaker cable is attached to the black terminal.

5. Slide the rubber grommet over the terminal, ensure the whole of the terminal is covered.

Terminal

4. Ensure the speakers are facing in the desired direction and tighten.

Once the speaker has been attached to the wake tower, the speaker cables can be attached.

S PK0 08

Grommet

Speaker Wire

6. Connect the other end of the speaker wire to your amp or stereo system.

T E C H N IC A L S P E C IF IC AT IO N A N D C UTTI N G TEMPLATE

SPK008

Speaker driver specifications SPK008 System - mm (inches) Power Watts Tweeter - mm (inches) Midrange - mm (inches) Efficiency (1M/1W) db Frequency Response Impedance (Ohms) Weight - kgs (lbs)

152 x 229 (6” x 9”) 210 13 (½”) Neo PEI dome x 2 51 (2”) mylar cone 91 60 Hz–22 kHz 4 4.15 (9.1)

WARRANTY GME limit this warranty to the original purchaser of the equipment.

GME warrant the SPK008 to be free from defects in material and workmanship for a period of thirty six (36) months from the date of purchase from their authorised retailer.

Should the product require servicing during this period, all labour and parts used to effect repairs will be supplied free of charge.

GME reserve the right to determine whether damage has been occasioned by accident, misuse or improper installation whereby the warranty would be void, including equipment which has been damaged due to: (a) Incorrect or reverse polarity connection to a battery or power supply or to an incorrect supply voltage. (b) Operation without an antenna or by connection to an antenna which has been incorrectly installed, resulting in damage to the speaker’s output circuit.

Procedure to be followed by claimant: In the event of a defect occurring during the warranty period, the original purchaser may return the defective unit along with suitable proof of purchase date (i.e. receipt, docket, credit card slip etc.) and a full description of the defect to the retailer from whom the unit was purchased. All freight charges incurred for transportation by the retailer or GME are the purchaser’s responsibility.

GME AFTER SALES SERVICE Your speaker is especially designed for the environment encountered in land and marine installations. The use of all solid state circuitry, careful design and rigorous testing, result in high reliability. Should failure occur however, GME maintain a fully equipped service facility and spare parts stock to meet the customer’s requirements long after expiry of the warranty period.

(c) Effects of water or moisture penetration. (d)

Non-factory modifications.

S PK0 08

T E C H N IC A L S P E C IF IC AT IO N A N D C UTTI N G TEMPLATE

SPK008

A Division of

Standard Communications PTY. LTD.

Head Office: Sydney- Locked Bag 2086, North Ryde, NSW 1670, Australia.

Tel: +61 (0)2 9844 6666 Fax : +61 (0)2 9844 6600 MELBOURNE ADELAIDE PERTH BRISBANE SYDNEY AUCKLAND 7 Micro Circuit 14 Phillips Street Unit 1 Unit 1 Unit B Unit 2 DANDENONG STH 3165 THEBARTON 5031 10-12 Harvard Way 89-101 Factory Road 22-24 College Street 24 Bishop Dunn Pl. Tel: (03) 9798 0988 Tel: (08) 8234 2633 CANNING VALE 6155 OXLEY 4075 GLADESVILLE 2111 East Tamakii Fax: (03) 9798 0177 Fax: (08) 8234 5138 Tel: (08) 9455 5744 Tel: (07) 3278 6444 Tel: (02) 9879 8888 MANUKAU 2013 NZ

Fax: (08) 9455 3110 Fax: (07) 3278 6555 Fax: (02) 9816 4722 Tel: (09) 274 0955

Fax: (09) 274 0959 For customers outside Australia and New Zealand please contact your local GME Distributor or email: export@gme.net.au Part Number: 310437 Drawing Number: 44317-2

www.gme.net.au SPK008