spk010-2_im

SPK010 MARINE 10 INCH

SUBWOOFER

T e c h n i c a l s p e c i f i c a t i o n s & C U T T IN G T E M PLA T E

Mounting instructions

Speaker driver specifications

CONNECTING

SPK010

1. Attach the speaker wire (not supplied) to the speaker terminals.

Be sure to connect the striped wire to the negative (–) terminal, and the other wire to the positive (+) terminal of the speaker.

Power (Watts) Efficiency (1W/1M) Frequency Response Impedance (Ohms)

2. Connect the other end of the speaker wires to your amplifier ensuring the negative wire goes to the negative terminal and the positive goes to the positive terminal. GME recommends 6 mm (0.2”) speaker wire is used when cable runs are no longer than 5 metres (5.5 yards).

Cone Material

420 86 db 30 Hz-2 kHz 4 Polypropylene

Magnet Structure

30 Oz

Grilles

Plastic

To Amp

Weight (kgs)

3.26

MOUNTING

WARRANTY

1. Using the template supplied for this subwoofer, mark the correct mounting location, ensuring there is enough space behind the location to accommodate the speaker.

GME limit this warranty to the original purchaser of the equipment.

GME warrant the SPK010 to be free from defects in material and workmanship for a period of thirty six (36) months from the date of purchase from their authorised retailer.

2. Push out the template from this leaflet and use to mark the position of the mounting screws and the outline of the speaker hole. Drill the mounting holes and cut the hole for the speaker.

4. Connect the speaker wire as per the earlier instructions.

Should the product require servicing during this period, all labour and parts used to effect repairs will be supplied free of charge. GME reserve the right to determine whether damage has been occasioned by accident, misuse or improper installation whereby the warranty would be void, including equipment which has been damaged due to:

5. Mount the woofer using the screws supplied.

(a) Incorrect or reverse polarity connection to a battery or power supply or to an incorrect supply voltage.

6. Place the plastic grille back over the subwoofer.

(b) Operation without an antenna or by connection to an antenna which has been incorrectly installed, resulting in damage to the speaker’s output circuit.

3. R emove the grille of the speaker.

7. The GME SPK010 is a ‘Free Air’ Subwoofer. A Free Air system consists of woofers mounted to a board attached to an isolated space in the boat. The board and space acts as an enclosure which houses the subwoofer and isolates sound from the back of the speaker, solving the sound cancellation problem of subwoofers without an enclosure.

265 mm

(c) Effects of water or moisture penetration.

10.4”

(d) Non-factory modifications.

112 mm 4.4”

Procedure to be followed by claimant: In the event of a defect occurring during the warranty period, the original purchaser may return the defective unit along with suitable proof of purchase date (i.e. receipt, docket, credit card slip etc.) and a full description of the defect to the retailer from whom the unit was purchased. All freight charges incurred for transportation by the retailer or GME are the purchaser’s responsibility.

GME AFTER SALES SERVICE Your speaker is especially designed for the environment encountered in land and marine installations. The use of all solid state circuitry, careful design and rigorous testing, result in high reliability. Should failure occur however, GME maintain a fully equipped service facility and spare parts stock to meet the customer’s requirements long after expiry of the warranty period.

A Division of Standard Communications Pty. Ltd. Head Office: Sydney- Locked Bag 2086, North Ryde, NSW 1670, Australia. Tel: +61 (0)2 9844 6666 Fax : +61 (0)2 9844 6600

MELBOURNE ADELAIDE PERTH 7 Micro Circuit Unit 1, 14 Phillips Street Unit 1, 10-12 Harvard Way DANDENONG STH 3165 THEBARTON 5031 CANNING VALE 6155 Tel: (03) 9798 0988 Tel: (08) 8234 2633 Tel: (08) 9455 5744 Fax: (03) 9798 0177 Fax: (08) 8234 5138 Fax: (08) 9455 3110

BRISBANE SYDNEY AUCKLAND Unit 1, 89-101 Factory Road Unit B, 22-24 College Street Unit 2, 24 Bishop Dunn Place OXLEY 4075 GLADESVILLE 2111 East Tamaki, MANUKAU 2013 Tel: (07) 3278 6444 Tel: (02) 9879 8888 Tel: (09) 274 0955 Fax: (07) 3278 6555 Fax: (02) 9816 4722 Fax: (09) 274 0959

For customers outside Australia and New Zealand please contact your local GME Distributor or email: export@gme.net.au www.gme.net.au

Part Number: 310438 Drawing Number: 44318-2

lle

(P

ole

(Pu

o sh

ut)

Sp ea

ke rh

Ou t er

ed

Tear off here

ge

ke ea sp f o

ri rg

) out h s u

SPK0 10

TECHNICAL SPECIFICATION AND CUTTING TEM PLATE

SPK010 Cutting Template

SPK010

TECHNICAL SPECIFICATION AND CUTTING TEM PLATE