FITTING INSTRUCTION FOR DOOR LEVERS ON 52mm SQUARE ROSE – PASSAGE PAIR NOT SUPPLIED WITH LATCH
1 If fitting to a new door drill 12mm hole for spindle in correct position based on lock / latch backset.
2 Insert spindle (C) supplied into latch follower with open groove facing down.
3 Place handles over spindle, ensuring correct handle is used for each side of the door. Check for free action.
4 If handles do not fit flush to door cut an equal amount off each end of the spindle (C), in this
H
event you may also need to cut an appropriate amount off the M4 x 60mm through bolts (D). A
5 Remove handles. Using allen key (G) provided loosen square rose and remove, taking care not to scratch metal body.
C
6 (a) If fitting tubular latch mark out hole positions vertically above and below spindle at 41mm centres. Drill 6mm holes squarely from both sides to avoid exit splintering.
A
6 (b) If fitting a mortice latch or lockcase with thru bolt piercings mark out hole positions horizontally either B
side of spindle at 41mm centres. Drill 6mm holes squarely from both sides to avoid exit splintering.
D D
7 Place handles onto spindle and fix using M4 x 60mm through bolts (D). Fit self tapping screws into other countersunk holes (E or F depending on door thickness). If mortice case does not have FIXINGS SUPPLIED
piercings for thru bolts use 4 wood screws per lever.
C B E
8 Replace square roses and tighten with allen key (G).
D FIXINGS LIST (A)
1 of M6 grub screw (spare)
(B)
1 of M6 allen key
(C)
1 of 8 x 8 x 110mm slotted spindle
(D)
2 of M4 x 60mm thru bolts
(E)
4 of #4 x 19mm wood screws
(F)
4 of #4 x 25mm wood screws
(G) 1 of M5 allen key (H) 1 of M5 grub screw (spare) PART NUMBER : 35697
9 Using allen key (B) provided, tighten grub screw at base of handle body. Retain allen key for F
future use.
A CONTACT G
T : +44 (0)1271 325 325
H E : sales@turnstyledesigns.com
W : www.turnstyledesigns.com
Turnstyle Designs Ltd, Baron Way, Roundswell Business Park, Barnstaple, Devon, EX31 3TB, United Kingdom