Yarn Splicer Heberlein® AirSplicer-40-2 For knot free joining of filament yarns including glass fibers The Heberlein® AirSplicer-40-2 enables the best splicing quality with flat, clean bound yarn ends and highest strength. Suitable for yarns used for magazine creeling, in drawing and twisting processes or for fabric manufacturing. Splicing of Multifilament Yarns During splicing the ends of two yarns are intermingled by using compressed air. The resulting joint exhibits high uniformity and base yarn strength. In contrast to a knotted joint, a splice causes less problems in the following processes since the yarn has a more uniform structure. Area of Application Recommended for the knot free joining from 800 up to 17‘000 dtex and glass fiber rovings from 70 up to 2‘400 tex. Product Benefits The robust design of the splicer guarantees problem-free operation, even under severe conditions with the highest splicing quality and longest lifespan. The automatic splicing cycle, independent of the operator, serves to ensure high and reproducible splice quality. Handling The splicing time ranges from 0.5 - 2 seconds and is dependant on the material and pressure. It can be set freely according to requirements due to the premarked adjusting screw for easy reference.
Service For long term cutting tests with new types of fibre our splicing robot with original unit is available. For further information please apply to our customer service department.
The blow chambers are easily replaced by releasing two screws.
Oerlikon Heberlein Temco Wattwil Inc. Bleikenstrasse 11 · 9630 Wattwil, Switzerland T +41 71 987 44 44 · F +41 71 987 44 45 www.components.oerlikontextile.com · info.heberlein@oerlikon.com
Yarn Splicer Heberlein® AirSplicer-40-2 Range of Application Type 1)
Synthetic filament yarns [dtex]
Cellulose filament yarns [dtex]
Dyneema® [dtex]
Glass fibers [tex]
C
3‘000 –
6‘000
400 –
600
B
5‘000 –
9‘000
600 –
900
A
7‘000 – 13‘000
900 –
1‘600
O
– 17‘000
–
2‘400
1 2)
– 17‘000
–
2‘400
2-F
900 –
1‘800
900 –
1‘800
70 –
200
–
800
2-E
1‘800 –
2‘500
1‘800 –
2‘500
200 –
400
–
1‘800
1 Splicing jet insert (Blow chamber) 2 Suitable for high single filament count
For an optimal splicing result the choice of the correct splicing jet, the time of splicing and air pressure applied corresponding with the type and fineness of the yarn is important. It is also possible to splice yarns over 7 dpf or with more than 150 TPM, subject to trial. For special demands we offer optimisation trials with your yarns.
Dimensions and Weight
Compressed Air Requirements
75
122
Air pressure (gauge):
4 – 7 bar
Max. residual oil: (2*)
0,1 mg/m3
Accessories
Max. residual particles: (2*) – Particle size 1 μm – Particle density 1 mg/m3
209
Max. residual water: (5*) – Residual water 7,732 g/m – Dew point + 7 °C * According to DIN ISO 8573-1 quality
DN 10
Weight 1‘140 g
Subject to change without prior notice · © 2012 Oerlikon Heberlein Temco Wattwil Inc., 9630 Wattwil, Switzerland 740321/04
Stands with foot activation switch