1 minute read

EASYTRAK PLATE WITH L10 GW BINDING

TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT WITH ISO 5355 STANDARD AND SKI BOOTS EQUIPPED WITH « GRIPWALK » LABELLED KIT OF WALKING SOLES

Advertisement

✖ ✖

ISO 5355 WTR ISO 9523

WARNING

THESE ALPINE BINDINGS ARE INTENDED TO BE USED ONLY WITH THE FOLLOWING SKI BOOTS:

> Alpine ski boots compliant with ISO 5355 standard. > Ski boots equipped with « GripWalk » labelled kit of walking soles WITHOUT metal inserts

Any use with other ski boots could cause the ski-binding-boot system to be faulty and affect release characteristics, which would increase the risk of serious injury while skiing. Therefore, skiers are warned not to use this product with any ski boots other than those meeting the standards indicated above. Skiers are advised to consult the dealer where this product was purchased, or an equipment specialist at any SALOMON authorized ski dealer of this product, for further information regarding which ski boots meet the standards listed above.

SOLE LENGTH ADJUSTMENT

Ski Woman (W) premounted in factory: 253mm – 320mm / Size L: 257mm – 380mm

MOUNTING & ADJUSTING

1

1. For mounting L10 GW binding on skis, holes have to be drilled with the Salomon mounting jig (ref 30863001) to ensure a proper alignment of the binding.

ALPINE SKI BOOTS (ISO 5355)

TYPE A (Adult)

TYPE C (Children)

GRIPWALK BOOTS (ISO 9523) NO NORM SKI BOOTS

Diameter

Skis

Length Drill bit length

Diameter Length Reference Aspect

2. Mount the front and the rear plate on ski by tightening the screws at 4 N.m

2

3. Insert the toe and the heel piece and position on the track according to the boot sole length.

3

4. Step-in the boot and check the forward pressure

4

5. Select and adjust the setting release values for toe and heel pieces

5

This article is from: