WARDEN MNC 11 DEMO BINDING

from Salomon Tech Manual Alpine 2020/21

by Salomon

WARDEN MNC 11 BINDING

TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT WITH ISO 5355 STANDARD, TOURING BOOTS COMPLIANT WITH ISO 9523 STANDARD, SKI BOOTS EQUIPPED WITH “WTR TECHNOLOGY” PADS OR WITH “GRIPWALK” PADS

ISO 5355 WTR

ISO 9523

WARNING

THESE ALPINE BINDINGS ARE INTENDED TO BE USED ONLY WITH THE FOLLOWING SKI BOOTS:

> Alpine ski boots compliant with ISO 5355 standard. > Touring boots compliant with ISO 9523 standard > Ski boots equipped with “WTR technology” pads or with “GRIPWALK” pads

Any use with other ski boots could cause the ski-binding-boot system to be faulty and affect release characteristics, which would increase the risk of serious injury while skiing. Therefore, skiers are warned not to use this product with any ski boots other than those meeting the standards indicated above. Skiers are advised to consult the dealer where this product was purchased, or an equipment specialist at any SALOMON authorized ski dealer of this product, for further information regarding which ski boots meet the standards listed above.

SOLE LENGTH ADJUSTMENT

262mm – 382mm

MOUNTING & ADJUSTING

1. For mounting Warden 11 MNC DEMO binding on skis, holes have to be drilled with the Salomon mounting jig (ref 39109101) to ensure a proper alignment of the binding. Mount the front and the rear plate on ski by tightening the screws at 4 N.m ▼

2. Insert the heel and brake piece from the back and position on the plate according to the boot sole length. ▼ 3. Insert the toe piece from the front and position on the plate according to the boot sole length. ▼ 4. Boot sole length adjustment. ▼ 5. Step in the boot. ▼ 7. Adjust the toe height with adjustment screw until to create a gap of the thickness of the mounting instruction sheet between the boot sole and the