OPEN SOURCE

Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat.

*Note for 3D printing:

with E-Sun wood PLA we noticed good precision in the prints, especially for interlocks and holes, but only in sizes over 2 mm. The holes for interlocking the sun logos on the lampshade were enlarged using a file and a x-acto knife, in order to allow the interlocking of the logos. For the other holes and interlocks, the precaution used in slightly widening them after the first prints (made with Sunlu white PLA+) proved itself too precautionary, keeping the size and not guaranteeing the necessary friction needed to maintain the interlock. This was resolved by adding a few layers of paper tape (2-3 layers in the majority of cases). To be more precise, the holes with the added layers were: the interlocks on the lampshade the contact points between the two halves of the connector and the arm pin the hole for the arm pin the hole on the arm for the passage along the lamp cylinder

Slide the reflector for a diffuse reflection

Slide the reflector for a direct reflection

Turn the light off