Rev 2:0
111E
BMW X3 (F25) 2010— (Inc Facelift) BMW X4 (F26)
Powder Coated Finish
e11*94/20*9502*00 Components
Code
Quantity
CB
1
Description Crossbar
Bolt Kit Code
Quantity
WA
4
12mm Large Round Washers
PPF
6
Push in Plastic Fasteners
w91
Description
1. Remove rear light clusters — remove plastic trim from inside of light cluster and 2 nuts. Pull lights rearward and disconnect wiring loom. 2. Remove bumper. Remove fixings on top corners of bumper under each light cluster. Remove plastic fixings from wheel arch trim (3 either side) and gently ease trim from arch to reveal fixings behind and remove them. Remove fixings near to the wheel arch base. Remove 5 fixings from lower edge of bumper securing bumper to under tray. Remove reflectors (prise from inside edge) to reveal fixings behind and remove them. With the aid of lubricant pull away bumper tips and unclip bumper sides. Disconnect reversing sensors (plug on left hand side). Remove under tray (4 nuts). 3. Temporarily remove the plastic bumper supports from the outside rear panel (4 nuts either side). Remove the rear impact beam (hand back to customer). Retain fixings. 4. Loosely attach crossbar CB to impact beam mounting studs with washers WA and original fixings. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing, then replace bumper. 5. Cut out slot in under tray as shown in diagram. Re-attach under tray.
6. Check andon the towbar drawing. tighten all fasteners using a calibrated torque tool to the specified torque settings 111recommended .
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com