Rev 2:1
155ED
Powder Coated Finish
PEUGEOT 508 SALOON 2011E11 55R-0110125
w602
Components
Mainframe
Description
Bolt Kit
Code
Quantity
Code
Quantity
Description
CB
1
Crossbar
WA
8
8mm Large Round Washers
LB
1
Left Bracket
WB
2
10mmSmall Round Washers
RB
1
Right Bracket
WC
4
12mm Small Round Washers
LS
1
Left Strap
B
8
8x40 Set Screws & Grip Washers
RS
1
Right Strap
E
2
10x35 Set Screws & Grip Washers
A
4
12x50 Set Screws, Grip Washers & 2 Nuts
(Neck Type) Detachable 'D'
Please See Detachable Neck Box Contents List
Please See Detachable Neck Box Contents List
1. Remove all trim panels from inside the boot. 2. Remove bumper—2 wheel arch screws & 1 tip screw either side. Peel back wheel arch liner to reveal 1 torx screw either side. Remove light clusters (plastic nuts behind each cluster). 1 torx screw inside bumper each side. 4 fixings & 1 nut on lower edge. With the aid of lubricant unclip the bumper tips by gently pulling outwards. Disconnect any wiring attached to the bumper. 3. Remove and discard the left hand impact beam bolts. 4. Loosely attach left bracket LB using set screws B with washers WA. 5. Repeat the process on the Right hand side with right bracket RB. 6. Remove the tape covering the threaded points on each chassis rail & loosely attach side straps LS & RS to the chassis rails using set screws E with washers WB. 7. Loosely attach crossbar CB & side straps LS & RS to brackets LB & RB using set screws A with washers WC. 8. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing. Detachable Neck: Attach to crossbar CB using set screws Z. 9. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing. 10. Cut bumper as shown in diagram. 11. Refit bumper, wiring, light clusters & boot trim.
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com
Rev 2:1
155ED
Powder Coated Finish
PEUGEOT 508 SALOON 2011-
Bolt Torque Settings Bolt Size (mm)
Pitch (mm)
Torque Setting (Nm) 8.8 Tensile
5
0.80
6.09
6
1.00
10.50
8
1.25
25.30
10
1.25
46.00
10
1.50
50.90
12
1.25
83.00
12
1.50
87.81
12
1.75
87.27
14
2.00
139.00
16
2.00
213.00
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com