Rev 2:8
PEUGEOT 5008
161ED 161E
Powder Coated Finish
2010 — February 2017 Excludes models fitted with AdBlue tank e11*94/20*9536*00 w496
Components
Mainframe
Code
Quantity
Description
CB
1
Crossbar
LA
1
Left Angle
RA
1
Right Angle
LSP
1
Left Side Plate
RSP
1
Right Side Plate
Bolt Kit Code
Quantity
Description
WA
8
10mm Small Round Washers
B
4
10x40 Set Screws & Grip Washers
E
4
12x50 Set Screws, Grip Washers & 2 Nuts
NT
4
10mm Nuts & Grip Washers
(Neck Type) Detachable 'D'
Please See Detachable Neck Box Contents List
Please See Detachable Neck Box Contents List
Flange Neck 'F'
Please See Flange Neck Box Contents List
Please See Flange Neck Box Contents List
1. Bumper removal is not necessary but will ease fitting off the angles. Non removal of bumper method shown. 2. Remove 4 fixings securing lower arch liners to bottom corners of bumper. Fold arch liner away from the bumper to gain access to the rear impact beam fixings. Better access is achieved by removing the fog lamps from the lower bumper. 3. Remove the 2 lower bumper beam bolts (2 each side). Remove the lashing eyes if fitted together with the exhaust hanger. The lashing eyes will not be refitted. 4. Loosely attach angles LA and RA to the lower bumper beam using set screws B with washers WA. 5. Loosely attach side plates LSP and RSP together with the exhaust hanger bracket to the threaded studs on the chassis rails using nuts NT with washers WA. 6. Position crossbar CB up inside the bumper and loosely attach to side plates and angles (see diagram) using set screws E. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing. Detachable Neck: Attach to crossbar CB using set screws Z. Flange Neck: Attach to crossbar CB using bolts A and type approved towball (not supplied) using set screws G. 7. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing.
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com
Rev 2:5
161ED 161E
Powder Coated Finish
PEUGEOT 5008 Excludes models fitted with AdBlue tank
Bolt Torque Settings Bolt Size (mm)
Pitch (mm)
Torque Setting (Nm) 8.8 Tensile
5
0.80
6.09
6
1.00
10.50
8
1.25
25.30
10
1.25
46.00
10
1.50
50.90
12
1.25
83.00
12
1.50
87.81
12
1.75
87.27
14
2.00
139.00
16
2.00
213.00
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com