Rev 2:1
203E
CITROEN C3 2002 -
Powder Coated Finish
e11*94/20*4797*00
Components Code
Quantity
CB
1
PL
1
SP
1
Av123
1
Bolt Kit
Description
Code
Quantity
Crossbar
WB
6
8mm Large Round Washers
Plate
WA
4
10mm Large Round Washers
Spacer
C
2
16x50 Bolts, Nuts & Grip Washers
Towball Cover
A
4
10x30 Bolts & Grip Washers
B
2
10x30 Bolts, Nuts & Grip Washers
w572
Description
1.
Remove the two plastic fixings from the bottom edge of the bumper.
2.
For each mudguard, remove the plastic fixings securing the centre of the mudguard (located near the top spring mountings).
3.
Pull out the rearmost edge of each mudguard from behind the bumper lip to give access to the chassis mountings.
4.
The mounting points are covered with sealant tape, locate their position on the outward facing surface of the chassis rail near its end flange. Carefully remove the sealant tape to expose the threaded mounting holes.
5.
Remove the two flanged nuts securing the rearmost exhaust rubber mounting and pull the exhaust mounting off its two studs.
6.
Loosely fit plate PL using bolts A and washers WA.
7.
Position crossbar CB above the exhaust pulling the bottom edge of the bumper skin away from the car to increase access. Loosely attach to the outward facing surface of the left hand chassis rail using bolts A and washers WA and to plate PL using bolts B. Note: take care to protect the bumper surface from scratching during assembly of the crossbar.
8.
Tighten all bolts starting with chassis mountings.
9.
Loosely refit the exhaust mounting using spacer SP to space the bracket off the chassis rail.
10.
Remove the two flanged nuts securing the rubber exhaust mounting on the forward end of the silencer and fit two washers WB to each stud. Refit the rubber mounting and fully tighten the two nuts. Tighten remaining exhaust mounting nuts on the rear mounting.
11.
Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing.
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com
Rev 2:1
203E
Powder Coated Finish
CITROEN C3 2002 -
Bolt Torque Settings Bolt Size (mm)
Pitch (mm)
Torque Setting (Nm) 8.8 Tensile
5
0.80
6.09
6
1.00
10.50
8
1.25
25.30
10
1.25
46.00
10
1.50
50.90
12
1.25
83.00
12
1.50
87.81
12
1.75
87.27
14
2.00
139.00
16
2.00
213.00
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com