Rev 1:4
228E
ISUZU RODEO PICK UP 2003-2012
Powder Coated Finish
(4WD & 2WD with and without chrome bumper/ step) e11*94/20*9700*00
Components Code
Quantity
CB
1
LP
1
RP
1
SP
1
Description
Bolt Kit Code
Quantity
Crossbar
WB
6
12mm Small Round Washers
Left Plate
WA
4
10mm Large Round Washers
Right Plate
G
2
16x50 Bolts, Nuts & Grip Washers
Spacer
A
4
10x40x1.25 Bolts & Grip Washers
B
6
12x40x1.25 Bolts & Grip Washers
C
6
12x35 Bolts, Nuts & Grip Washers
w1172
Description
VEHICLES WITH BUMPER 1. Disconnect fog lights and number plate wiring from rear bumper. Remove bumper — 3 bolts either side of chassis. NOTE:- due to weight and size of bumper, two people may be required to handle the bumper. Loosen the bolts securing the bumper arms to bumper. 2. Loosely attach left plate LP and right plate RP to the chassis rails using bolts A with washers WA. 3. Replace rear bumper back onto the vehicle. Loosely attach bumper and plates LP and RP to the chassis rails using bolts B with washers WB. NOTE:- D-MAX Models— a clearance hole must be drilled in the bumper arms for upper most bolts. 4. Loosely attach crossbar CB to plates LP and RP using bolts C. 5. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing and replace fog lights. NOTE:- Due to the placement of the fog light, it may need to be repositioned. VEHICLES WITHOUT BUMPER 1. Remove and disconnect rear fog lamp. 2. Loosely attach left plate LP and right plate RP to the chassis rails using bolts A with washers WA and bolts B with washers WB. 3. Loosely attach crossbar CB to plates LP and RP using bolts C. 4. Attach approved towball (Not Supplied) with spacer SP using bolts G. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing NOTE:- The rear fog lamp may require re-positioning to avoid hitting the crossbar.
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com
Rev 1:3
228E
Powder Coated Finish
ISUZU RODEO PICK UP
(2WD & 4WD with & without chrome bumper/ step)
Bolt Torque Settings Bolt Size (mm)
Pitch (mm)
Torque Setting (Nm) 8.8 Tensile
5
0.80
6.09
6
1.00
10.50
8
1.25
25.30
10
1.25
46.00
10
1.50
50.90
12
1.25
83.00
12
1.50
87.81
12
1.75
87.27
14
2.00
139.00
16
2.00
213.00
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com