Rev 2:1
236E
Powder Coated Finish
PEUGEOT 307 ESTATE & SW 2002e11*94/20*5774*00
Components Code
Quantity
CB
1
CS
1
LA
1
RA
Description
Bolt Kit Code
Quantity
Crossbar
WA
6
8mm Large Round Washers
Centre Strut
WB
8
10mm Large Round Washers
Left Angle
NT
2
8mm Nuts & Grip Washers
1
Right Angle
A
4
8x30 set screws & Grip Washers
AG
4
Angles
F
2
16x50 Set Screws, Nuts & Grip Washers
ST
2
Straps
C
4
10x50 set screws, Nuts & Grip Washers
D
2
10x40 Set Screws, Nuts & Grip Washers
E
2
12x90 Bolts, Nuts & Grip Washers
B
4
10x30 set screws, Nuts & Grip Washers
w1170
Description
1. Lower rear exhaust. Remove the three bolts securing the underside of the rear bumper to the car body and also the nut fasteners. (note: the outer 2 nuts, reverse the opposite way round to reconnect the bumper). 2. Remove the 2 lowest bumper beam bolts on each side of vehicle. Loosely attach angles LA and RA to fixing points on vehicle using set screws A and washers WA. Note: it may be necessary to temporarily loosen the two upper bumper beam bolts on each side and push the bumper upwards while fully tightening set screws A. 3. Loosely attach angles AG to angles LA and RA using set screws B. Position crossbar CB over exhaust and between angles AG and loosely attach to angles AG using set screws D. Loosely attach straps ST to the outer chassis rail studs using nuts NT with washer WA. Attach straps ST to crossbar CB using set screws C with washers WB. 4. Loosely attach centre strut CS to crossbar CB using bolts E. 5. Attach type approved towball (not supplied) using set screws F. 6. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing. 7. Reconnect bumper and exhaust.
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com
Rev 2:1
236E
Powder Coated Finish
PEUGEOT 307 ESTATE & SW
Bolt Torque Settings Bolt Size (mm)
Pitch (mm)
Torque Setting (Nm) 8.8 Tensile
5
0.80
6.09
6
1.00
10.50
8
1.25
25.30
10
1.25
46.00
10
1.50
50.90
12
1.25
83.00
12
1.50
87.81
12
1.75
87.27
14
2.00
139.00
16
2.00
213.00
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com