Rev 2:6
215ED 215E
Powder Coated Finish
RENAULT MEGANE III HATCHBACK (3 & 5 Door) (Inc Coupe) 2008-2016 e11*94/20*8288*00 w532
Components
Mainframe
Description
Bolt Kit
Code
Quantity
Code
Quantity
CB
1
Crossbar
WA
2
10mm Large Round Washers
Description
LS
1
Left Strap
WB
6
12mm Large Round Washers
RS
1
Right Strap
C
2
10x35 Bolts & Grip Washers
B
6
12x40 Bolts, Grip Washers & 2 Nuts
(Neck Type) Detachable 'D'
Please See Detachable Neck Box Contents List
Please See Detachable Neck Box Contents List
Flange Neck 'F'
Please See Flange Neck Box Contents List
Please See Flange Neck Box Contents List
1. Remove rear light clusters. 2. Remove bumper (1 fixing under each light unit, 2 torque screws in each wheel arch and 1 tip screw behind arch liner, 3 torque screws on lower edge). Free bumper tips out from plastic securing clips and pull rearwards. Disconnect wiring loom. 3. Remove boot floor covering, spare wheel padding and rear impact beam. Remove silver foil from ends of chassis and retain. If necessary remove metal tab from left chassis rail. Remove bolt securing exhaust hanger to chassis. 4. Insert left strap LS and right strap RS inside the chassis rails and loosely secure using bolts C and washers WA. Note: These holes will be covered with tape. 5. Insert mainframe CB inside the chassis rails, secure using bolts B with washers WB. (Access to the left inner fixing is gained by removing the air-vent blanking plug). 6. Tighten all bolts, cut a slot in both pieces of silver foil and refit over the ends off the chassis rails. Use sealant to prevent water ingress. Replace bumper, light clusters and exhaust hanger bolt. Detachable Neck: Attach to crossbar CB using set screws Z. Flange Neck: Attach to crossbar CB using bolts A, then attach towball A50/1 (not supplied) using bolts G. 7. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing.
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com
Rev 2:4
215ED 215E
Powder Coated Finish
RENAULT MEGANE III HATCHBACK (3 & 5 Door) (Inc Coupe)
Bolt Torque Settings Bolt Size (mm)
Pitch (mm)
Torque Setting (Nm) 8.8 Tensile
5
0.80
6.09
6
1.00
10.50
8
1.25
25.30
10
1.25
46.00
10
1.50
50.90
12
1.25
83.00
12
1.50
87.81
12
1.75
87.27
14
2.00
139.00
16
2.00
213.00
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com