Rev 2:1
262E 262ED 262ES
Powder Coated Finish
VOLKSWAGEN PASSAT (B8) SALOON 2014- & ESTATE 2015E11 55R-01 1064 w337
Components
Mainframe
Code
Quantity
CB
1
Crossbar
Description
ST
2
Straps
Bolt Kit Code
Quantity
WA
6
12mm Large Round Washers
Description
B
2
12x40 Set Screws & Grip Washers
C
4
10x40 Set Screws & Grip Washers
(Neck Type) Detachable 'D'
Please See Detachable Neck Box Contents List
Please See Detachable Neck Box Contents List
Swan Neck 'S'
Please See Swan Neck Box Contents List
Please See Swan Neck Box Contents List
Flange Neck 'F'
Please See Flange Neck Box Contents List
Please See Flange Neck Box Contents List
1. Remove light clusters, 1 plastic fixing on each inside boot, slide rearwards and disconnect wiring harness. 2. Remove bumper. 4 screws in each wheel arch, 1 screw at tip. 6 screws and 4 plastic screws on lower edge, pull bumper tips out then rearwards to release from clips. Disconnect reversing sensor loom. 3. Remove impact beam, re-fit original fasteners to prevent water ingress. 4. Remove any tape covering the mounting points on the chassis. Place straps ST inside the chassis rails and loosely attach using set screws C with washers WA. 5. Place crossbar CB inside the chassis and loosely attach to straps ST using set screws C with washers WA and set screws B with washers WA. 6. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing. Cut out factory marked area inside bumper. Re-fit bumper. Detachable Neck: Attach to crossbar CB using set screws Z. Swan Neck: Attach to crossbar CB with CPE10 plates (Reverse Orientation) using set screws Y & bolts W. Flange Neck: Attach to crossbar CB using bolts A then attach type approved towball (not supplied) using bolts G. 7.
Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing.
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com
Rev 2:1
262E 262ED 262ES
Powder Coated Finish
VOLKSWAGEN PASSAT (B8) SALOON 2014- & ESTATE 2015-
VOLKSWAGEN PASSAT SALOON/ ESTATE 2014-
Bolt Torque Settings Bolt Size (mm)
Pitch Torque Setting (mm) (Nm) 8.8 Tensile
5
0.80
6.09
6
1.00
10.50
8
1.25
25.30
10
1.25
46.00
10
1.50
50.90
12
1.25
83.00
12
1.50
87.81
12
1.75
87.27
14
2.00
139.00
16
2.00
213.00
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com