Rev 2:2
412ED 412ES 412E
FORD EDGE 2016-
Powder Coated Finish
E1155R –0111116
Components
Mainframe
Code
Quantity
CB
1
LA RA
Description
Bolt Kit Code
Quantity
Crossbar
WA
6
14mm Large Round Washers
1
Left Angle
WB
2
12mm Large Round Washers
1
Right Angle
B
6
14x40 Set Screws
E
2
12x40 Set Screws
w578
Description
(Neck Type) Detachable 'D'
Please See Detachable Neck Box Contents List
Please See Detachable Neck Box Contents List
Swan Neck 'S'
Please See Swan Neck Box Contents List
Please See Swan Neck Box Contents List
Flange Neck 'F'
Please See Flange Neck Box Contents List
Please See Flange Neck Box Contents List
1. Remove the bumper – six fixings inside each wheel arch, eight fixings along lower edge. Release clips along side and top edges of bumper. 2. Remove impact beam, eight fixings 3. Insert angles LA and RA into the chassis and loosely secure using set screws B and washers WA, set screws E with washers WB. 4. Check and tighten all fasteners using a calibrated torque tool to the specified torque settings recommended on the towbar drawing. 5. Replace the bumper. Detachable Neck: Attach to crossbar CB using set screws Z. Swan Neck: Attach to crossbar CB with CPE10 (standard orientation) using set screws Y & bolts W. Flange Neck: Attach to crossbar CB using bolts A. Attach type approved towball (not supplied) using set screws G.
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com