Rev 2:1
806E
NISSAN NOTE 2006-2013
Powder Coated Finish
e11*94/20*6533*00
Components Code
Quantity
CB
1
LA
1
RA
1
LC
Description
Bolt Kit Code
Quantity
Crossbar
A
3
12x 40 Bolts & Grip Washers
Left Angle
B
5
12x40 Bolts, Nuts & Grip Washers
Right Angle
C
2
12x90 Bolts, Nuts & Grip Washers
1
Left Cleat
D
2
16x50 Bolts, Nuts & Grip Washers
RC
1
Right Cleat
NT
4
10mm Nuts & Grip Washers
LCS
1
Left Captive Strap
WA
4
10mm Large Round Washers
RCS
1
Right Captive Strap
WB
8
12mm Large Round Washers
F
1
Neck
w1178
Description
1.
Remove bumper fixings on lower edge, screws inside wheel arches, 1 tip screw either side in wheel arches, 2 fixings either side on boot shut panel, unclip sides of bumper and release clips on upper edge and disconnect and wiring where necessary.
2.
Cut bumper as per diagram.
3.
Remove plastic bumper support from lower valance and cut as per diagram.
4.
Insert captive plates LCS and RCS in to chassis rails inserting them in the holes provided.
5.
Loosely attach cleats LC and RC to captive plates using nuts NT and washers WA.
6.
Insert angels LA and RA into the chassis rails and loosley attach together with cleats LC and RC using set screws A+B with washers WA.
7.
Attach crossbar CB to angels LA and RA using bolts B with washers WA .
8.
Tighten all fixings using a calibrated torque tool to the specified torque settings on the towbar drawing.
9.
Replace lower bumper support.
10. Replace rear bumper. 11. Attach neck F to crossbar CB using bolts C. 12. Attach type approved towball (not supplied) to neck F using bolts D . 13. Check and tighten all fasteners using a calibrated torque tool to the recommended torque settings on the towbar drawing.
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com
Rev 2:1
806E
Powder Coated Finish
NISSAN NOTE
Bolt Torque Settings Bolt Size (mm)
Pitch (mm)
Torque Setting (Nm) 8.8 Tensile
5
0.80
6.09
6
1.00
10.50
8
1.25
25.30
10
1.25
46.00
10
1.50
50.90
12
1.25
83.00
12
1.50
87.81
12
1.75
87.27
14
2.00
139.00
16
2.00
213.00
PLEASE REFER TO YOUR VEHICLE HANDBOOK FOR THE MAXIMUM TOWING WEIGHT This product is finished in a revolutionary industry leading powder coat finish.
Towsure Products Limited, Holme Lane, Hillsborough, Sheffield, S6 4JR T: 0114 250 3000 E: sales@towsure.com
www.towsure.com