Fitting Instructions
TOWBAR F101A For IVECO TIPPER
MATERIALS A 1 Tubular Mainframe B 1 10mm Coupling Packer D 1 Left hand sidearm E 1 Right hand sidearm F 4 Cleat G 2 End Caps H 8 M12 x 40 x 1.75 Bolts, Nuts, Lock Washers and 6 off Flat washers 30mm O.D. J 8 M14 x 40 x 2.00 Bolts and Nyloc Nuts CB 2 M16 x 50mm Coupling Bolts, Nuts, Lock Washers ZEP35 Electrical Plate FITTING Note: On vehicles where the chassis has been shortened the holes in chassis may not be present and will require drilling using the Sidearms (D) and (E) as a guide (ensure rearmost hole (J) on chassis is at least 30mm from end of chassis.) 1. 2. 3. 4.
On vehicles where holes are present, open out existing hole (J) in chassis for rearmost Bolts (J) (M14). Loosely secure Sidearms (D)(E) and Cleats (F) to chassis using bolts (H) and (J) with flat washers fitted as shown. Secure Tubular Mainframe (A) to Sidearms (D) and (E) using Bolts (J) and fully tighten all bolts. Fit End Caps (G).
NOTE: This towbar is EC type approved to be used with a Class A50-X towball with a ‘D’ Value greater than or equal to that of the towbar. Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed. Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS Deeside Ind. Park, Deeside, CH5 2NY
www.witter-towbars.co.uk
µW0001F101A-FIT$021210160000IÄ W0001F101A-FIT$021210160000
Issue 2