Fitting Instructions
TOWBAR FT71Q For FIAT DOBLO 2001-
MATERIALS A 1 Mainframe with European facing to 94-20-EC A50-1 C 2 Angle Bracket D 2 Side Arm E 2 Chassis Plates F 2 Bushes (19mm O.D. 73mm long) G 2 M10 x 100 x 1.5mm Bolts, Nuts, Lock Washers 4 Flat Washers (30mm O.D.) H 6 M8 x 35 x 1.25mm Bolts, Lock Washers and Flat Washers (25mm O.D.) J 2 M10 x 30 x 1.5 Bolts, Nuts, Lock Washers and 4 Flat Washers (20mm O.D.) K 4 M10 x 30 x 1.5 Bolts, Nuts and Lock Washers L 2 M10 x 30 x 1.5 Bolts, Nuts and Lock Washers EP 1 Electrical Plate ZQ 1 Quantum Detachable Unit (ZQ2070) FITTING 1. Remove the middle part of the bumper (4 Torx screws on top edge, 2 Torx screws on bottom edge and 2 screws on bottom edge). Remove the steel beam (6 M8 bolts at (H) on rear panel). Remove the upper rubber grommets, lower plastic plugs for fixing (G). Clear mastic from (G and J) as required. 2. Loosely attach Mainframe (A) to rear panel using upper fixings (H). Attach Chassis Plates (E) to Mainframe (A) and vehicle chassis using lower Bolts (H) and Bolts (J). 3. Insert Bushes (F) and loosely attach Angle Brackets (C) with Large Flat Washers (30mm O.D.) between angle Bracket and Chassis using Bolts (G). Attach Side Arms (D) to Mainframe (A) using Bolts (K) and Angle Brackets (C) using Bolts (L). 4. Assemble Electrical Plate (EP) and Quantum Detachable Unit (ZQ) to Cross Bar (A) using separate fitting instructions. 5. Finally tighten all Bolts and replace the bumper. This towbar must be used with a Witter Towball (part number ZQ2070). Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed. Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm , M14 - 150 Nm, M16 - 214 Nm
G
J
F
K
E
H
D
H K
C
L
H
A
E
F D EP
C
G
H L
ZQ
E
K
K
WITTER TOWBARS Deeside Ind. Park, Deeside, CH5 2NY Tel: 01244 284500 Fax: 01244 284577
Issue 2