iPhone 6 Plus Home Button Replacement

iPhone 6 Plus Home Button Replacement

When your iPhone broken the screen or dropped into water, you pick up it and check it. You may have noticed that over time your iPhone ’s Home button becomes less responsive. If you press the button it either results in a delay, lag or sometimes is completely unresponsive, forcing you to click multiple times. Here’s a solution to recover your iPhone ’s Home button if you’re finding it unresponsive or laggy seriously. You need to take it apart for it.

Replacement Steps: One: Remove the iPhone 6 Plus Display 1. Power off your iPhone. And remove the two screws on either side of the Lightning port. Apply a suction cup to

the lower left corner of the display assembly. Pull up on the suction cup with firm, then pull out a seam. With the spudger to widen the gap between the front panel and the rear case. Then pull up on the suction cup.

2. Use a plastic opening tool to hold down the rear case while pulling up the suction cup to open the phone. Keep the display to make sure protect the data cables connecting the display near the top edge of the iPhone.

Finally, Pull up the suction cup from the display.

3. Gently grasp the display assembly and lift it up to open the phone. Then easily tear the digitizer, and front camera cables.

Two: Replace the iPhone 6 Plus Home Button

1. Remove the following Phillips screws securing the battery connector bracket to the logic board, Then remove the battery connector bracket. Use the pointed tip of the spudger to disconnect the battery connector from the logic board.

2. Remove the following Phillips screws: Three 1.3 mm screws, One 1.6 mm screw, One 3.0 mm screw. Then remove the display cable bracket. Pry up the connector.

Use a plastic opening tool to disconnect the digitizer cable by prying. Remove the display assembly.

3. Remove the two 1.9 mm Phillips screws securing the home button bracket. Remove the home button bracket.

Use the pointed tip of a spudger to disconnect the home button cable. Using your fingertip to separate the home button's rubber gasket from the front panel. Remove the home button assembly.

More information about smartphone or iPhone repair guide and tools, pls follow vipfixphone.com.