How to Fix iPhone 6s can't Boot after Normal Use

How to Fix iPhone 6s can't Boot after Normal Use When the iPhone has some problems of software or hardware, you had to feel distraught and send it to repair shop. Now we say the topic that is the iPhone 6 can't boot after normal use. Maybe you will think it is caused by ill-functioning software. But in the strict sense, this may be the fault of the internal components of the iphone, and it needs to fix by repair tools. Now Vip FIx Shop Team will help you to solve this problem, hoping you can benefit from it.

First we need check the iPhone problems. Open the iPhone screen to check if there are the traces of water corrosion, battery resistance is normal, then power on and

test

with

multimeter(2A am

multimeter

is

recommended) directly up voltage to 1.8A, it belongs to the symtom of high current.

How to Fix the iPhone 6s Boot Problem?

1. Tear down all the accessories and starting with a single iPhone 6S motherboard, the result is the same, so you can be sure that the accessories or parts are ok. Before we fixed a lot of large current cell phone devices, power on and directly measure value, making sound is basically the components on VCC main power supply get problem, but the situation of current up to 1.8A is still relatively rare. After determining the measurement, we can confirm the problem is from VCC circuit, for big current device, you can use rosin with electric solder iron, apply rosin on the solder iron and work on VCC main circuit components, it will produce white smoke, power on again, you can see Q2300 charging switch tube quickly shine. The part is shown in picture 10-1-1.

This will make people think that the booting problem is caused by this parts, according to our experience, it's not caused here. Two circuit power supply is shown in picture 1-1-2.

2. Because this component focuses on B+ and VCC power supply, so it's heating firstly, but it can be determined that it's not bad, for 6S 1.8V device, you can directly focus the problem on backlight part. As shown in picture 10-1-3, the backlight part is easy to burn out.

3. Open the iPhone CPU shield (setting spiral hot air gun 260 degrees can easily take off, avoid high temperature, so as to avoid CPU solder explosion), we find

the

traces of components are burn out on the two backlight diode and C4023, it is best to pack first before processing elements near the CPU. As shown in picture 1-1-4.

4. Disassemble two diode and a capacitor and power on again is normal, deal with the solder pad with low temperature solder. you should be gentle when handling

it since the pad is easy to fall off. Replacing the new components, reboot and test, every function is normal now. As shown in picture 1-1-5.

Note: If the diode is installed in the reverse will appear large current phenomenon, after the replacement, you can test again by solder iron with rosin so that will be more intuitive to see whether it is installed, C4023 capacitor must be installed, otherwise it is easy to burn the iPhone backlight IC.

5. This iPhone 6S problem is solved after replacing two diodes and capacitor C4023. Some of the backlight IC and backlight inductance get yellow, which will be required to be replaced. 6S backlight parts are easy to be broken, and the components are all covered with glue.

When you remove it, don't be impatient. It will be convenient for the following work after the glue is

removed.

All the problems have been solved, the iPhone 6s recover well.