3/32 ALLEN
TEE NUT ALLEN SCREW
Assembling the NoLOX Door Lock Solution
1/8 BIT
NoLOX LOCKING ARM
Fig 1: The components in this package include one of each: NoLOX Locking Figure 1 Arm, Allen Screw and Pronged Tee Nut.
LOCK LEVER RUBBER CAP
7/32 BIT
Figure 2
Figure 3
You will need 1/8” and 7/32” drill bits plus a 3/32 Allen wrench, a center punch, a ball peen hammer and Phillips screwdriver. Fig 2: NoLOX will work on either right or left hand door handles. Fig 3: Remove the rubber cap on the lock lever. Position the NoLOX Locking Arm against the door handle plate.
DRILL 1/8 PILOT HOLE FIRST THEN FOLLOW UP WITH THE 7/32 BIT
Figure 4
This is a critical stage. Make sure the NoLOX Locking Arm is level and snug against the lock lever. Mark the position of the Locking Arm with a sharp pencil. Unscrew the three plate screws and remove the plate. Fig 4: Use a piece of wood to support the plate and make an indentation with the punch where you will drill.
Figure 5
Figure 6 TRIM 1/8” TO 3/16” OFF RUBBER CAP
TEE NUT ON INSIDE OF PLATE WITH PRONGS FACING DOWN
Figure 7
Figure 8
Figure 9
Fig 5: Drill a pilot hole with the 1/8” drill bit then follow with the 7/32” bit. Fig 6 & 7: Assemble the NoLOX Locking Arm components to the plate. We recommend using a drop of Loctite on the Allen screw. Fig 8: Place the plate back onto the door. Make sure to align the door handle with the opening mechanism. Re-install the three plate screws. Fig 9: Trim 1/8”- 3/16” off the lock lever rubber cap so the Locking Arm clears. Fig 10: Completed project with Locking Arm in safe mode. Fig 11: To unlock, simply pinch Locking Arm in a downward motion. Fig 12: If necessary to make the NoLOX Locking Arm easier to lock/unlock, trim a small portion off the TOP of the Locking Arm as shown. To view instructions on your phone, in camera mode, point your phone at this code. Open link.
UNLOCKED POSITION
SAFE MODE
Figure 10
Figure 11
Figure 12
Strengthen Your Interior Door Handle
A
The components for this fix include a Flat Shim, a Fender Washer and a Phillips Head Screw. You will need a 10-32 tap and Phillips screwdriver for this project. While you have the door handle plate off: A) Tap the existing hole on the back of the handle. B) Place the shim. C) Place flat washer and insert screw. We recommend using a drop of Loctite on the screw. You’re done!
B
C
NoLOX - Door Lock Solutions Send inquiries or questions to: noloxsolution @ gmail.com