Landscape Construction - Union Canal, Fountainbridge, Edinburgh

150

1750 D05

205

D02

400

7650 D01

D03

D04

To Fountain park, North of this site

To the bank of Union Canal 10mm joints layed with high performance mortar

Pavings

40mm asphalt 6mm chips

230(L)x120(W)x50(H)mm stone

50mm dense bitumen macadam 12mm gauge

30mm sharp sand compacted

150mm final compacted MOT type 1 sub-base

150mm final compacted MOT type 1 sub-base

Compacted subgrade

Compacted subgrade

Edgings Surface Preparation for furniture (Refer to LC02) - All furnitures are placed on top of stone pavings. pavings have been installed - Cast furniture on site directly on top of the concrete to ensure precision of

200(L) x 100(W) x 60(H)mm Precast concrete block laid in stretcher bond

5mm joint sharp sand

Epoxy mortar

20mm 1:3 cement sand mortar 3000 x 150 mm Gen 1 and haunch

Audrey Chan s1433555 BA2 Landscape Architecture University of Edinburgh EH3 9DF

NCR754 Union Canal Edinburgh EH11 Coordinates: 55.940532, -3.213484 Drawing Title:

D03 - Precast Concrete Block Edging

Drawing Surface Treatment Project Title: Detail Design Landscape

1200(L) x 400(W) x unknown (H)mm polished stone slab

Date:

be determined

14-03-2016 D04 - Edging to Bank of Canal

Scale:

As Specified Drawing No.

The area of the precast concrete varies according to the dimensions of the furniture.

The area should be (1.2xW) x (1.2x L), where W and L are the longest Width and Length of the furniture

20mm 1:3mm sand cement mortar

135

500(L) x 150(W) x 305(H)mm

NA

Sheet No.

LC01

Drawn by: Audrey Chan Approved by:

300 x 150mm Gen 1 concrete

Sheet Size

A3

A

D04

3700

50mm Bark Mulch

400mm High quality soil

D03

D05

Geotextile membrane that filters the water D04 - 1:10 Detail to the installation of the wooden slat, to the concrete bench

D02 - 1:10 section to the contents of the planting box

Project Location:

1:20 Plan of the Bench

D06

7.2 12.8

880 D02

880 x 100 x 20mm waterproof treated douglas fir wooden slats

10 20

D05 - 1:5 Detail to the bolts on the wooden slat

M12 1mm Countersunk washers

A

General Furniture Information: - Outdoor bench with a large planting block attached at the back - Cast on site with dark grey stained D01 concrete (in situ concrete) - Concrete surfaces that are visible to the public will have a different finishing from the ones invisible.

- Wooden slats are installed on site A-A: 1:20 Section with contents in the planting box after the concrete sets.

-Perennials are going to be planted in the planting block -5 drainage holes are going to be drilled at the bottom of the bench to create drainage for plants.

M12 65mm socket countersunk bolts

1mm flat stainless steel washer + 9mm rubber spacer

10

1mm flat stainless steel washers

in situ concrete bench

35

12mm Diameter x 9mm rubber spacers

14

D06 - 1:2 Detail to the bolts installation to the wooden slat and concrete

Audrey Chan s1433555 BA2 Landscape Architecture University of Edinburgh B EH3 9DF

B

1410

D03 - 1:10 Detail to Drainage Pipe at the bottom of the bench

100mm 10-20mm Gravel drainage layer

2290

B-B: 1:20 Section

36mm resin filler locking in the bolts into the concrete, into a 36 x 14mm hole

D01 - 1:5 Section detail

NCR754 Union Canal Edinburgh EH11 Coordinates: 55.940532, -3.213484 Drawing Title:

Construction Drawing Furniture Project Title: Detail Design Landscape Construction Date: 14-03-2016 Scale:

As Specified Drawing No.

NA

Sheet No.

LC02

Drawn by: Audrey Chan Approved by:

Sheet Size

A3

15mm

N

Exisitng manhole on site

rds wa l to k fal l ban e p a slo can 2% the

150mm

3mm

1:20 plan - Location of slot drain

130mm

150mm Width Slot Drain (Refer to D01)

400 x 1200mm stone slab

150mm

230 x 120 x 50 mm Stone setts paved with 10mm joint.

There are two types of installation method for this slot drain, depending if the structure below the stone slab can be altered, because it possibly can be a retaining structure to go against the hygdraulic pressure from the water in the bank.

ELEVATION AND ISOMETRIC VIEW AT SCALE 1:10 If that underground structure can be altered (Refer to D02)

Concrete bed and Haunch with a minimum strength class of C20/25 should be casted approximately 10mm below the stone slab. The dimension of this concrete bed should be at least 600mm in length and at least 150mm deep from the bottom of the slot channel. Gaps between the paving blocks to the concrete bed are connected with a layer of Epoxy mortar.

DRAINAGE PLAN (NOT TO SCALE)

If the underground structure cannot be altered (Refer to D03)

15mm

Concrete bed and Haunch with minimum strength class of C20/25 should be casted around the slot channel, in which the channel is surrounded by concrete bed at least 150mm wide (from the edge of the the channel), and 150mm deep (from the bottom of the channel).

Slot channel 10mm Epoxy mortar bedded between the paving blocks and the concrete bed.

150mm deep Concrete bed and Haunch with a minimum strength class of C20/25 D02 - 1:10 DETAIL DRAWING SLOT CHANNEL INSTALLATION IF GROUND UNDER STONE SLAB CAN BE ALTERED

Underground structure under the stone slab. Detail still to be confirmed.

NCR754 Union Canal Edinburgh EH11 Coordinates: 55.940532, -3.213484 Drawing Title:

Drawing Drainage/SUDs Project Title: Detail Design Landscape Date: 14-03-2016 Scale:

As Specified Drawing No.

NA

SCALE 1:50

Sheet No. Slot channel

150mm

130mm

3mm

150mm

Audrey Chan s1433555 BA2 Landscape Architecture University of Edinburgh EH3 9DF

150mm Concrete bed and Haunch with a minimum strength class of C20/25

ELEVATION AND ISOMETRIC VIEW AT SCALE 1:10

D01 - PRODUCT ADAPTED FROM ACO DRAIN. SLOT DRAINAGE PRODUCT DRAWING SHOWN IN THE SCALE SPECIFIED.

D03 - 1:10 DETAIL DRAWING SLOT CHANNEL INSTALLATION IF GROUND UNDER STONE SLAB CANNOT BE ALTERED

Underground structure under the stone slab. Detail still to be confirmed.

LC03

Drawn by: Audrey Chan Approved by:

Sheet Size

A3