Peculiar Parts

Traveling Wave Tubes

Peculiar Parts, the Series

By Neil Gruending

The world of RF amplifiers is fascinating because of the wide range of methods in use. Today, many are constructed from solidstate components, but there are still situations where vacuum tubes are the only suitable choice. We’ve looked at klystrons in the past, so, this time, let’s look at the traveling-wave tube amplifier, another unsung electronic hero.

One of the most fascinating things about traveling-wave tube amplifiers is how they work. They feature a heater, cathode, and acceleration electrodes to form an electron gun, much like a cathode-ray tube, that beams a stream of electrons to the collector (Figure 1). This stream is focused by an external magnetic field that is usually made of permanent magnets. Using velocity modulation, which mixes the electron stream with the incoming RF electrons, the tube amplifies the applied RF input signal.

HEATER

N ELECTRODES

CATHODE DRIFT TUBE

INPUT ANTENNA HELIX ATTENUATOR PERMANENT MAGNETS

S OUTPUT ANTENNA COLLECTOR

N

1 2 INPUT WINDOW

S OUTPUT WINDOW

TO HEATER CATHODE VO LTAG E TO ELECTRODE VOLTAGES TO HELIX VO LTAG E TO R-F INPUT TO R-F OUTPUT TO COLLECTOR VO LTAG E

Figure 1: Basic design of a traveling-wave tube.

Figure 2: Collins Radio S-Band traveling-wave tube amplifier used for communication with earth during the Apollo mission. (Source: Ken Shirriff)

Figure 3: Operating at several thousand volts, the Collins Radio amplifier was a tightly-packed tangle of coaxial cables. (Source: Ken Shirriff)

Since the streaming electrons travel much more slowly than the RF electrons, the RF signal is fed through a spiral wound wire, called the helix. This slows the RF signal down to match that of the electron stream.

As the RF electrons proceed down the helix, they modulate the velocity of the electrons in the stream because the in-phase electrons speed up, and the out-of-phase electrons slow down. These modulated electrons then bunch together, inducing an amplified signal back into the helix that is then picked off the end of the helix using a directional coupler.

When compared to klystrons [1], traveling-wave tubes have the advantage of wider bandwidths. Additionally, they don’t require resonant components, making them ideal for lower power microwave applications like radar or even spacecraft and satellites. A great example is the Collins Radio S-Band amplifier (Figure 2 and Figure 3) used in the Apollo space program [2]. It was a compact, 32-pound, 20-W amplifier that transmitted all of the voice, data, and television back to NASA’s network of 26-m, earth-based dish antennas. By comparison, the ground station used a focused 10,000-W signal to communicate back to the craft.

Even though traveling-wave tubes are mostly the domain of commercial applications, a small group of enthusiasts still like experimenting with these wonderful little amplifiers in amateur microwave transmitters [3]. Their biggest challenge, however, is finding the tubes!

210418-01

Questions or Comments?

Do you have technical questions or comments about this article? Email Elektor at editor@elektor.com.

WEB LINKS

[1] N. Gruending, “Klystrons, Weird Component # 12,” Elektor 3/2015: https://bit.ly/2UW4k9G [2] K. Shirriff, “Inside a 20-Watt Traveling-Wave Tube Amplifier from Apollo,” Ken Shirriff’s Blog, July 2021: https://bit.ly/3ea8lOn [3] H. Griffiths, “Travelling Wave Tube Amplifiers,” The National Valve Museum, September 1980: https://bit.ly/3wA8aCn