1 minute read

SMARTRAK GRIP / GRIP PLUS BINDING

SMARTRAK GRIP / GRIP PLUS BINDING TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

WARNING : BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT TO ISO 5355 STANDARD

Advertisement

CONTENTS OF THE BOX

› 2 Toes › 2 Heels mounted on a sliding part › 2 Brakes › 2 Thin Plates › 1 Notice

MOUNTING

AND AJUSTING

1. Insert the Thin Plate in the seating ahead the plate (fig. 1). 2. Place it correctly with a rotational motion (fig. 2). 3. Identify the length of the boot. 4. Identify the letter that corresponds your sole length. (If you are between two, choose the higher one) (fig. 3). 5. Screw the center mounting track to this letter. (4Nm Torque) (fig. 4).

Mount the Toe piece as usual (fig. 5). 6. From the rear, slide the Heel piece on the interface using the manual lock to authorize the sliding (fig. 6). 7. Mount the Brake following the usual procedure (fig. 7). 8. Position your boot in the toe and slide the heel until it touches the boot (fig. 8). 9. Step in the boot and check forward pressure (fig. 9).

The arrow on the housing must be within the scribed area Info: The rear N° is an indication for a quick adjustment of the second ski (fig. 10).

1

4

5

7

2

8

3

6

9

10

NO

OK

This article is from: