SMARTRAK BINDING

TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

WARNING : BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT TO ISO 5355 STANDARD

CONTENTS OF THE BOX

› 2 Toes mounted on a sliding part › 2 Heels mounted on a sliding part › 2 Brakes › 2 Thin Plates › 1 Notice

SOLE LENGTH ADJUSTMENT

257mm – 380mm

MOUNTING

1. Insert the Thin Plate in the seating ahead the plate (fig. 1). 2. Place it correctly with a rotational motion (fig. 2). 3. From the rear, slide the Toe piece on the interface until it corresponds with or is just above your boot sole length using the manual lock to authorize the sliding (fig. 3a & 3b). 4. From the rear, slide the Heel piece on the interface until it corresponds with or is just above your boot sole length using the manual lock to authorize the sliding (fig. 4). 5. Mount the Brake following the usual procedure (fig. 5)

.

ADJUSTING EXAMPLE

6. Identify the length of the boot. 7. If you have boot sole L 306 mm, adjust the Toe on the 308 mm mark.

The range in this case is 301 mm to 308 mm (fig. 7). 8. If you have chosen the L 306 mm, adjust the Heel piece on the 312 location.

The range in this case is 305 mm to 312 mm (fig. 8). 9. Step in the boot and check forward pressure (fig. 9).

The arrow on the housing must be within the scribed area.

1

3b

7

8 2

4

3a

5

9

NO OK