SPEED PLATE + Z BINDING

TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

WARNING : BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT TO ISO 5355 STANDARD

ISO 5355

WTR ISO 9523

WARNING

THESE ALPINE BINDINGS ARE INTENDED TO BE USED ONLY WITH THE FOLLOWING SKI BOOTS:

> Alpine ski boots compliant with ISO 5355 standard.

Any use with other ski boots could cause the ski-binding-boot system to be faulty and affect release characteristics, which would increase the risk of serious injury while skiing. Therefore, skiers are warned not to use this product with any ski boots other than those meeting the standards indicated above. Skiers are advised to consult the dealer where this product was purchased, or an equipment specialist at any SALOMON authorized ski dealer of this product, for further information regarding which ski boots meet the standards listed above.

SOLE LENGTH ADJUSTMENT

260mm – 360mm

MOUNTING & ADJUSTING

1 – For mounting Z Speed bindings on skis, holes have to be drilled with the Salomon mounting jig (ref 11139301) to ensure a proper alignment of the binding.

2 – Mount the rear plate by tightening the screws at 4 N.m. ▼

3 – Mount the front plate by tightening the screws at 4 N.m. ▼

4 – Press and open the central lever. ▼

▼

5 – Mount the brake by tightening the screw at 4 N.m with tool Torx 25.

6 – Slide the toe piece from the front backward and the heel piece from the tail forward. ▼

▼

7 – Select the length of the sole boot and adjust the toe and heel pieces at the length corresponding. 8 – Close and lock on the central lever. 9 – Step in the boot and check the forward pressure.

▼