1 minute read

X TRACK PLATE WITH XT BINDING

TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

WARNING : BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT TO ISO 5355 STANDARD

Advertisement

ISO 5355

WTR ISO 9523

WARNING

THESE ALPINE BINDINGS ARE INTENDED TO BE USED ONLY WITH THE FOLLOWING SKI BOOTS:

> Alpine ski boots compliant with ISO 5355 standard.

Any use with other ski boots could cause the ski-binding-boot system to be faulty and affect release characteristics, which would increase the risk of serious injury while skiing. Therefore, skiers are warned not to use this product with any ski boots other than those meeting the standards indicated above. Skiers are advised to consult the dealer where this product was purchased, or an equipment specialist at any SALOMON authorized ski dealer of this product, for further information regarding which ski boots meet the standards listed above.

SOLE LENGTH ADJUSTMENT

261mm – 381mm

MOUNTING & ADJUSTING

1. Remove the grey plastic part from the ski blade before toe assembly. ▼

2. Insert the toe piece from the front and position on the track according to the boot sole length. ▼

3. Insert the heel and break piece from the back and position on the track according to the boot sole length. ▼

4. Boot sole length adjustmen. ▼

5. Step in the boot and check forward pressure. ▼

6. Select and adjust the setting release values for toe and heel pieces. ▼

This article is from: