Ready/Rest Mode

Ready Mode : this mode will periodically circulate

the water using the low speed Hydromassage Pump for maintaining

a constant water temperature, heat it when necessary and update the

temperature display. This operation

it is called “polling”.

Rest Mode : in this mode the heating will be activated

only during the programmed filtering cycles. Since no polling takes place,

the screen may not show the temperature until the hydromassage pump

has been put into operation for one or two minutes. The main screen will show RUN PUMP FOR TEMP if the primary pump has not been running

for more than an hour. So far as the primary pump has been off for over

an hour, the pressure of any function button on the panel, except Light,

will start the pump and the heater so that we can detect and show the

temperature.

Main Screen

Press few times Menu/Select until MODE appears.

Set

To the next Menu if main Menu is not activated. Wait few seconds to get back to factory settings

Move between Ready (shown as ) and Rest shown as ). Pressing Menu/Select you will go back to main screen. Main Screen

Ready-in-Rest Mode : appears on the display when the

hot tub is in Rest Mode and the “Jets” button is pressed. This assumes

that the hot tub is in use and that it heats up to set temperature. The

hydromassage pump will run until reaches the set temperature or for a

maximum of one hour.

After an hour, the system changes to Rest mode. This mode can be

changed by simply entering the Mode menu and changing mode.

Legend

Shows a change in screen Shows progressive message – every 1/2 seconds Temperature button, used for “Action” Button Menu/Select Waiting time in which the chosen settings remain available. Waiting time when the initial settings are restored canceling the changes made.

Figure 14: mode selection screen