ENGLISH
READY/REST MODE Ready Mode
show RUN PUMP FOR TEMP if the primary pump has not been running
: this mode will periodically circulate
the water using the low speed Hydromassage Pump for maintaining a constant water temperature, heat it when necessary and update the
an hour, the pressure of any function button on the panel, except Light, will start the pump and the heater so that we can detect and show the
temperature display. This operation
temperature.
it is called “polling”. Rest Mode
for more than an hour. So far as the primary pump has been off for over
: in this mode the heating will be activated
only during the programmed filtering cycles. Since no polling takes place, the screen may not show the temperature until the hydromassage pump has been put into operation for one or two minutes. The main screen will
Main Screen
Legend Press few times Menu/Select until MODE appears.
Main Screen Set
To the next Menu if main Menu is not activated.
Ready-in-Rest Mode
Shows a change in screen Shows progressive message – every 1/2 seconds Temperature button, used for “Action” Button Menu/Select Waiting time in which the chosen settings remain available. Waiting time when the initial settings are restored canceling the changes made.
Wait few seconds to get back to factory settings Move between Ready (shown as ) and Rest shown as ). Pressing Menu/Select you will go back to main screen.
: appears on the display when the
hot tub is in Rest Mode and the “Jets” button is pressed. This assumes that the hot tub is in use and that it heats up to set temperature. The hydromassage pump will run until reaches the set temperature or for a maximum of one hour. After an hour, the system changes to Rest mode. This mode can be changed by simply entering the Mode menu and changing mode. -22-
Figure 14: mode selection screen
