Sensor alarms messages

Lack of water in the heater. Every function of the pool is disabled. After solving the problem, turn off and turn on the power again for initialize the

water heating procedure. Refer to the “water related problems at flusso” section below.

HTR DRY --- -

Overheated heater (OHH)* - MO30

Water temperature sensors have detected too many temperatures high,

47.8 °C (118 °F). All pool functions are disabled.

Press any button on the control panel to reset the heater operation when the water temperature is below 42.2 °C (108 °F). Refer to “Water

Problems at flusso” below. Figure 34: Message MO27

HTR TOO HOT --- -

A restore message may accompany other messages:

Some errors may require the power to be cut and then restored. Figure 35: Message MO30

PRE5 BTTN TO R5ET --- -

SENSOR ALARMS MESSAGES

Incorrect sensor calibration - MO15:

The sensors connected to the temperature measurement may be out of calibration by 3° F. Call technical service.

5N5R BAL - ANCE

Figure 36: Reset message

Incorrect sensor calibration* - MO26:

Figure 37: Message MO15

The sensors connected to the water temperature measurement ARE out of sync. There is a fault Incorrect calibration of the sensors for at least 1 hour.

Call technical service.