N C5 GW 2BINDINGS

N C5 GW BINDINGS

TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT WITH ISO 5355 STANDARD AND SKI BOOTS EQUIPPED WITH « GRIPWALK » LABELLED KIT OF WALKING SOLES

ISO 5355

WTR ISO 9523

WARNING

THESE ALPINE BINDINGS ARE INTENDED TO BE USED ONLY WITH THE FOLLOWING SKI BOOTS:

> Alpine ski boots compliant with ISO 5355 standard. > Ski boots equipped with « GripWalk » labelled kit of walking soles WITHOUT metal inserts

Any use with other ski boots could cause the ski-binding-boot system to be faulty and affect release characteristics, which would increase the risk of serious injury while skiing. Therefore, skiers are warned not to use this product with any ski boots other than those meeting the standards indicated above. Skiers are advised to consult the dealer where this product was purchased, or an equipment specialist at any SALOMON authorized ski dealer of this product, for further information regarding which ski boots meet the standards listed above. with the Salomon mounting jig (ref L7840610001) to ensure a proper alignment of the binding. to hold it so that it does not rotate.

Then slide the toe until it comes into contact with the holder screw and tighten the 2 screws at 3 N.m

ALPINE SKI BOOTS (ISO 5355)

(ISO 9523) NO NORM

TYPE A (Adult)

TYPE C (Children) TYPE A (Adult)

TYPE C (Children)

MOUNTING & ADJUSTING

1. For mounting N C5 GW binding on skis, holes have to be drilled

1

2. Screw the base, taking care

GRIPWALK BOOTS

2

3. Mount the heel taking care to tighten the 4 screws in the order indicated below at 3 N.m.

3

4. Step-in the boot and check the forward pressure

4

In case the forward pressure is not good, move the heel by the lever with the help of a screwdriver as explained in the images below.

5. Select and adjust the setting release values for toe and heel pieces.

Concerning the DIN setting of the heel, the end of the green indicator must be aligned with the number

5