4 Ways with your papers...

Zig-zag card Kit List

◆ 29.7cm x 17cm white card

◆ Card stock: lilac

◆ Craft flowers

◆ Adhesives: glue, 2mm foam tape

◆ Paper guillotine

Helping Hand

◆ Use box envelopes to protect your 3D cards in the post

◆ Place foam tape close to but not at the edge of elements so that it isn't on show. Colour in the edges carefully with felt-tip pen if some can be seen

Your Day Kit List

◆ 14cm x 14cm white gate-fold card

◆ Card stock: lilac

◆ Adhesives: glue, 2mm foam tape

◆ Paper guillotine

1 Cut diagonally across at the top of the card.

2 Cut a 13.5 square from lilac card and adhere to the card with foam tape, then glue a 13cm square from yellow card.

3 Cut a 12.5cm square of butterfly backing paper and adhere to the card with glue.

4 Cut a topper from the papers and stick onto the card with 2mm foam tape.

5 Cut a 13.5cm square from lilac card and cut diagonally in half. Adhere one triangle to the card front with foam tape.

6 Cut another topper from the papers and adhere to the centre of the card front using foam tape.

1 Score then fold the white card into a gate-fold card, with a 17.5cm back section and 12.2cm front flap. Score down the front flap at 6.1cm (valley) and fold back.

2 Cut two 5.8cm x 17cm rectangles and one 17cm x 17cm from lilac card and adhere to the card with glue.

3 Cut a 5cm x 15.8cm strip and 16cm x 16cm square from backing paper and

Thank You

Kit List

◆ 14cm x 14cm white card

◆ Card stock: lilac

◆ Craft flowers

◆ Adhesives: glue, 2mm foam tape

◆ Paper guillotine

1 Open the card and score from the centre top to bottom corner and fold back.

2 Cut a 13.5cm square from lilac card and adhere to the inside of the card with glue, then to a 13cm square of backing paper.

3 Cut an 8.5cm square from lilac card and adhere to the card with glue. Cut a topper from the papers and adhere to the inside of the card with 2mm foam tape.

4 Cut another 13.5cm square from lilac card and cut corner to corner to create adhere to the card with glue. a triangle. Cut another 13cm square from backing paper and cut corner to corner to create a triangle. Adhere these to the triangular front of the card with glue.

4 Cut a 11cm x 11cm from lilac card and stick to the card with 2mm foam tape.

5 Cut a topper from the papers and adhere to the card using 2mm foam tape.

6 Finish by adding a few flowers to two opposite corners with foam tape.

5 Cut an 8.5cm square from lilac card and stick onto the card with foam tape. Cut a topper from the papers and adhere to the front of the card with foam tape.