Electronic Cam Module
Selecting and protecting auxiliary power supplies Introduction Encoders, sensors and pre-actuators associated with the module require auxiliary power supplies (5VDC and/or 24VDC). Type of power supply Only use regulated power supplies to:
ensure optimum reliable response time for sensors and pre-actuators, increase the reliability of devices by minimum heating of module I/O circuits.
These power supplies must be independent enough (> 10ms) to override micro-power outages and ensure the module continues to run effectively. Protecting power supplies The power supplies for encoders, others sensors and pre-actuators need calibered fast-blow fuses against overloads and short-circuits. Connection of the 0V supply to the protective ground: The 0V supply must be connected to the protective ground nearest to the supply module output. General rules for installing the encoder power supply module
268
this must be used only for supplying the encoder, it must be independent enough to override micro-power outages (> 10ms). it must be placed as close as possible to the TSX CCY 1128 module to reduce circuit capacities to the maximum.
33002439 10/2019
