Winter 2022 / Step-by-Step
CREATING A LOW FADE
TEXTURED LOOK
From Pivot Point LAB, a bespoke VTCT learning resource, this step-by-step guide takes us through the procedures for creating a low fade, blending to high graduation and textured layers. 01
Consult with the client to determine the placement of fade, the length and desired interior texture.
02
02
Section both sides from the recession area horizontally to the crown. Remove internal perimeter lengths at the sides using clippers with guard on. Connect the sides, creating a slightly rounded line at centre back. Cut using C-strokes to keep the length at the top.
03
04
FOUR ZONES WILL BE USED TO CREATE THE FADE: • Each zone is approximately 1.25cm wide and slightly thicker towards centre-back • For Zone 1, make a bald area slightly above the hairline. On the left side, use the corner of trimmers and short C-strokes. Creating a curved line, work back to centre nape • Cut Zone 2 with no guard and clippers fully open • Blend Zones 1 and 2 with no guard and clippers half open • Further blend the bottom of Zone 2 to Zone 1 with no guard and clippers fully closed • Cut Zone 3 with a 3mm guard and clippers fully open • Blend Zones 3 and 2 with 3mm guard and clippers half open • Further blend the bottom of Zone 3 to Zone 2 with 3mm guard and clippers fully closed.
36 / Concept Hair
Courtesy of Pivot Point International, Inc. © 2022
