MODEL - SPECIFIC INSTRUCTIONS
WARDEN MNC 13 DEMO BINDING TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.
BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT WITH ISO 5355 STANDARD, TOURING BOOTS COMPLIANT WITH ISO 9523 STANDARD, SKI BOOTS EQUIPPED WITH “WTR TECHNOLOGY” PADS OR WITH “GRIPWALK” PADS
WTR
ISO 5355
ISO 9523
WARNING
Any use with other ski boots could cause the ski-binding-boot system to be faulty and affect release characteristics, which would increase the risk of serious injury while skiing. Therefore, skiers are warned not to use this product with any ski boots other than those meeting the standards indicated above. Skiers are advised to consult the dealer where this product was purchased, or an equipment specialist at any SALOMON authorized ski dealer of this product, for further information regarding which ski boots meet the standards listed above.
SOLE LENGTH ADJUSTMENT
262mm – 382mm
MOUNTING & ADJUSTING 1. F or mounting Warden 13 MNC DEMO binding on skis, holes have to be drilled with the Salomon mounting jig (ref 39109101) to ensure a proper alignment of the binding. Mount the toe piece and the rear plate on ski by tightening the screws at 4 N.m. ▼
2. Assemble the ski brake with the heel piece. ▼
BINDING
TECHNICAL MANUAL ALPINE 2020/21
THESE ALPINE BINDINGS ARE INTENDED TO BE USED ONLY WITH THE FOLLOWING SKI BOOTS: > Alpine ski boots compliant with ISO 5355 standard. > Touring boots compliant with ISO 9523 standard > Ski boots equipped with “WTR technology” pads or with “GRIPWALK” pads
76 summary <<<
>>>